Matchmaster Digimatch 03MM-DC21V User manual

Step 4
Cut the rubber boot seal provided and slide onto
stripped cable as in diagram.
Step 5
Strip coax cable as shown in diagram and feed through
rubber boot seal.
03MM-DC21V
VHF Ch (6-12) Digital Antenna Installation Instructions
Step 1
Snap out corner reectors and the end of the boom.
Step 3
Snap out elements on both booms so
they are at 90 degrees. Connect both
booms together using screw and wing
nut provided.
Step 2
Attach double folded dipole (‘G’ Unit) to boom using the
6mm (1/4”) hex head bolt washers and wing nut. Note:
The ‘G’ Unit is to be attached to the bottom side of the boom.
See diagram.

Step 6
Select connector provided.
(Suitable for RG6 or semi airspaced cable)
Place “F” connector on back to front and twist to
ensure that all braid is at. See diagram.
(For other cable types
you will need to purchase
the corresponding connector)
Step 8
Attach U bolt and mast
clamp as per diagram.
Step 9
Attach antenna to mast and point to
transmitter as per diagram. Rotate antenna
to achieve best results.
Attach cable with cable tie near u-bolt
and attach cable to mast with UV grade
insulation tape or UV grade cable ties to
support cable weight and avoid damage to
connection from wind whipping cable from
side to side.
For any technical enquiries, please call Matchmaster TV Reception Systems on
Toll Free Aust: 1800-AERIAL (1800-237425) or Toll Free NZ: 0800-AERIAL (0800-237425)
To Transmitter
Step 7
Then insert cable into rear of connector and twist connector
clockwise until dielectric is ush with the bottom nut as
in diagram. Ensure that 2-3mm of centre core conductor
protrudes past the nut.
Plastic Outer Case
Metal Braid
Dielectric
Metal Sheath Knurled Surface Core
Conductor