MATE Ultra TEC User manual

The Mate Logo and ULTRA TEC are registered trademarks of Mate Precision Tooling Inc.
Mate Precision Tooling • 1295 Lund Boulevard • Anoka, Minnesota 55303 USA • Phone [phone] • 800.328.4492 • Fax [phone] • 800.541.0285
mate.com
Installation/Length Adjustment Ultra TEC®
1 1/4” B Station Fully Guided Assembly
ATTACH 1TO 2…
Engage threads by rotating
punch approximately 8 turns
INSERT TIP OF CLIP TOOL INTO NOTCH
ON CLIP IN PUNCH GUIDE 3, (VISIBLE
IN PUNCH GUIDE CUTAWAY)…
Push latch pin down with
tool. Latch pin will release
stripper clip, which will pop
out ready for installation of
the stripper.
NOTE: Stripper clip is assembled
with the guide and is not removable.
NOTE: Head of latch pin is visible in
the notch cut into the stripper clip
(punch end view)
SELECT
ANGLE
SETTING...
INSERT
1AND 2
INTO 3.
SNAP 1AND 3
TOGETHER...
INSERT 4INTO 3
OVER TIP OF 2…
Items 3and 4are
precision fit components—
do not try to force fit or
damage may result. Keep
parts free of dirt or metal
shavings. If there is a lug on
4, align lug with
corresponding slot in 3.
LOCK 4INTO 3WITH INTEGRAL
STRIPPER CLIP…
NOTE: Stripper clip is
assembled with the guide
and is not removable. Use
finger pressure to push
stripper clip in until latch
pin snaps in place and
holds stripper securely.
The stripper clip will be
flush with or below punch
guide surface.
PUSHING DOWN LOCK BUTTON WILL
ALLOW THE CANISTER TO ROTATE...
ADJUST PUNCH
LENGTH…
While pushing down
lock button, set punch
face flush with stripper.
Turn canister six clicks
clockwise to retract
punch .048(1.2), to
provide proper stripper
lead.

The Mate Logo and ULTRA TEC are registered trademarks of Mate Precision Tooling Inc.
Mate Precision Tooling • 1295 Lund Boulevard • Anoka, Minnesota 55303 USA • Phone [phone] • 800.328.4492 • Fax [phone] • 800.541.0285
©2003 Mate Precision Tooling
LIT00036
Installation/Length Adjustment Ultra TEC®
1 1/4” B Station Fully Guided Assembly
PLACE PUNCH GUIDE ASSEMBLY
ON WORK SURFACE WITH
STRIPPER FACING UP...
INSERT TIP OF CLIP TOOL INTO
NOTCH ON CLIP (VISIBLE IN
PUNCH GUIDE CUTAWAY)…
Push latch pin down
with tool. Latch pin
will release stripper
clip, which will pop out
ready for removal of
the stripper.
NOTE: Stripper clip is assembled
with the guide and is not
removable.
PUNCH END VIEW
NOTE: Head of latch pin is visible in the notch
cut into the stripper clip.
ROTATE CANISTER TO INCREASE
LENGTH ADJUSTMENT…
Shoulder of punch will lift
stripper partially out of punch
guide. Do not attempt to pry
or lever stripper out of punch
guide. Rotate canister until
punch threads disengage.
Then turn assembly upside
down while supporting the
punch with one hand. Punch
and stripper will now drop out
of punch guide into your
hand.
ALIGN CANISTER…
Turn canister assembly until index mark is
aligned with the push buttons on the
punch guide.
DEPRESS BUTTONS AND
PULL ASSEMBLY APART…
Hint: The best way to
overcome button spring
pressure when
disassembling is to fully
depress your index finger
button and then your
thumb button. Following
this sequence will make
disassembly faster and
easier.