Matsui MTT4WE User manual

MTT4WE
Instruction Manual
GB

Cleaning The Filters

flashing

Cleaning the Filters
Filter assembly
For best performance and results, the filter assembly must be cleaned.
The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the
cycle. For this reason, it is a good idea to remove the larger food particles trapped in the filter after each
wash cycle by rinsing the semicircular filter and cup under running water. To remove the filter assembly,
pull on the cup handle in the upward direction. The entire filter assembly should be cleaned once a week.
To clean the coarse filter and the fine filter, use a cleaning brush. Then, reassemble the filter parts as
shown in the figures below and reinsert the entire assembly in the dishwasher, positioning in its seat
and pressing downward. The dishwasher must never be used without the filters. Improper replacement
of the filter may reduce the performance level of the appliance and damage dishes and utensils.
Never run the dishwasher without the filters in place. When cleaning the filters, don't knock on them .
Otherwise the filters could be contorted and the performance of dishwasher could be debased.
3. Disassembly the fiter, then clean the coarse filter.
Please clean the filter by blow steps when it blocked.
1. & 2. Take the filter system out from the dishwasher.
4.Clean the fine filter
5. Assembly the fine filter and coarse filter, then fix on the dishwasher.

L575 x W480 x H466 mm

Filter may be blocked
Check and unblock filter assembly
(page 8)
Connect to hot water inlet
Water inlet temperature may be lower than
normal,especially duringthe winter period
Filter may be blocked
Check and unblock filter assembly,
restart the appliance,check the
water lever goes down before the
wash cycle begins(page 8)
E3
E4
Obstructed spray arm Rotate the spray arm to ensure
free rotation
Poor Cleaning