Maxcare MAX-Q01A06RG User manual

超聲波噴霧補水儀
舒緩乾燥 自然保濕 滋潤肌膚
產品技術與參數
產品名稱
產品型號
額定電壓
額定電流
額定功率
內置電池
水箱容量
產品毛重
產品尺寸
輸入接口
主要材料
：超聲波噴霧補水儀
：MAX-Q01A06RG
：DC5V
：0.5A
：1.5W
：3.7V
：25ml
：95克
：37mm x 37mm x 146mm
：Micro USB
：ABS + PC + 電子
產品介紹:
通過高頻震動，將水分子分裂成超微粒子，可
迅速由角質層滲透至基底層，迅速補充皮膚缺
失水份，大大提高皮膚對外在營養和護膚精華
的吸收，是最完美的天然美容法。
使用方法:
* 補水儀工作時間為持續噴霧，需要使用時
點擊按鈕，工作時候藍燈亮起，同時出於
安全考慮，程序設置為1分鐘自動斷電關
機。
* 正常噴霧使用距離肌膚10厘米左右，上妝
後使用距離15厘米左右。
* 加水時請對準水箱加水口，避免水漏出來
(加水時請使用礦泉水)
產品保養和維護:
* 清潔之前，請確認電源開關已經關閉，電源
線插頭已經從插座拔出。
* 請用乾淨柔軟的棉布擦拭清潔產品。可使用
肥皂水浸濕的布棉擦去污垢。
* 切勿使用苯或稀釋劑等具有腐蝕性的清潔劑
來清潔此產品，否則可能會造成此產品褪
色，此產品結構受到腐蝕、開裂。
* 切勿將此產品放置於陽光直接照射或高溫的
場所，以免造成產品褪色及機件損壞。
* 如果長時間不使用此產品，請將水箱清潔乾
淨於陰涼乾燥處存放。
充電方法:
* 倒出水箱中剩餘的水，並安裝水箱上蓋。
* 機器底部連接配備的數據線 (也可用安卓手
機數據線替代) 另一端連接手機適配器或者
電腦USB接口
* 充電時盡量不要使用機器，會更好的延長電池
壽命，同時首次使用前請先充電3小時以上。
打開水箱上蓋 往水箱中注水 安裝水箱上蓋
温馨提示::
* 請添加天然礦泉水。可添加少量能溶於
水的精油及化妝水，比例為9:1 (水: 精油
/化妝水)。
* 使用前請先搖一搖。注入礦泉水後請將
瓶蓋擰緊，同時立即開機噴霧1分鐘左
右，避免噴霧口積水，如有少量積水，
用紙巾擦乾即可正常使用。
常見問題及處理方法
問題
儀器不工作
儀器開機顯示
燈亮但不噴霧
或噴霧量小
儀器有漏水
解決方法
電量不足，請即時充電
1. 水箱裏沒有水，注水後重
新開機。
2. 電量不足，需重新充電。
3. 噴霧口有積水，需要用面
簽或紙巾抹乾。
4. 噴霧口堵塞，需要清潔水
箱。
水箱沒扭緊，請扭緊。
MAX-Q01A06RG
產品使用說明書

Technical Specifications
Product Name
Product Model
Rated Voltage
Rated Current
Rated Power
Battery
Capacity
Gross Weight
Product Size
Input Interface
Material
：Nano Water Mist
：MAX-Q01A06RG
：DC5V
：0.5A
：1.5W
：3.7V
：25ml
：95g
：37mm x 37mm x 146mm
：Micro USB
：ABS + PC + Electronic
FAQs and Solutions
MAX-Q01A06RG
User Manual

Moisturize skin · Soothe dry skin
Product introduction:
Nano Water Mist is equipped with high-tech chip
control, producing a finer mist that quickly enters
the skin pores, reducing wrinkles, relieving skin
irritation, and also promoting skin metabolism and
improving skin pigmentation.
How to use:
* Please press the power button to turn on the
mist, and blue light indicates being in use.
With the time memory function, the Nano
Water Mist will automatically power off in 60
seconds.
* The skin without makeup is sprayed from
about 10cm, and the makeup skin should be
sprayed from around 15cm, which will not
mess up your makeup.
* Please fill in the water from the port. (Please
use mineral water)
Cleaning and Maintenance
* Before cleaning, please make sure the switch
has been turned off, and the power plug has
been pulled out from socket.
* Please use a piece of clean and soft cotton
cloth to clean this product. The cloth can be
soaked in soap water first, but please dry it to
damp before cleaning.
* Do not use corrosive cleaning agents like
benzene or thinner to clean the product,
otherwise, the color of product will fade, and
the internal parts may be corrupted or broken.
* Please keep the product away from direct
sunlight, or high temperature, to avoid fading.
* Please clean the water tank and store in a dry
place if not in use for long.
How to charge:
* Pour out all the water, and install the cap.
* Please use the equipped cable to connect the
USB port. (Android phone data cable can
replace it)
* Please don’t use the Nano Water Mist when it
was charging, extended battery life for better
usability. And please charge for 3 hours when
first time to use.
Open the
water tank
Fill water into
the water tank
Tighten
the cap
Reminder:
* Please fill with natural mineral water. If
you want to add toner or essential oil,
please add water to make a dilution
according to the ratio of 1:9.
* Please shake it before use. Must need
tighten cap after fill in the mineral water.
Then turn on the Nano Water Mist for 1
minute. Dry the mist port with tissue
when it was wet.
Issues
Product not
functioning
Product was
on but not
functioning or
the mist was
small.
Product was
leaks
Solutions
Battery is low, put on charge
immediately.
1. The water tank was out of
water, fill water into the water
tank and restart the Nano
Water Mist.
2. Battery is low, put on charge
immediately.
3. Dry with tissue when there
are leak in the mist port.
4. Clean the water tank when
there are something clogged.
Please screw the cap.