Maxis TG799vn User manual

RESIDENTIAL
GATEWAY
Model TG799vn
User Manual

1. ECHNICAL SPECIFICA IONS
1.1 Hardware Specifications
1.2 Management
1.3 Services
1.4 irewall Security
1.5 Wireless Performance and Security
2. HARDWARE SE UP
3. LED BEHAVIOR
4. INS ALLA ION REQUIREMEN
5. DEC SE UP
5.1 Mounting the Docking Station
5.2 Connecting the DECT Phone
5.3 Register TH58 to TG799vn
6. EASY SE UP
7. MANUAL SE UP
8. WIRELESS CONFIGURA ION
9. POR FORWARDING CONFIGURA ION
10. DMZ CONFIGURA ION
11. USB FILE SHARING
4
4
5
5
5
6
6
7
9
10
10
11
11
12
17
20
23
25
27
CON EN S

12. USB PRIN ER SHARING
13. ROUBLESHOO ING
14. RESE O FAC ORY DEFAUL
15. FIRMWARE UPGRADE
31
34
36
37

1.1 HARDWARE SPECIFICA IONS
Interfaces
WAN
•RJ11 DSL line port
•GE uplink - ETH WAN Gigabit
•ull X0
LAN
•3-port autosensing 10/100Base-T auto-MDI/MDI-X Ethernet switch
•1-port Gigabit Ethernet LAN
•2 XS POTS interfaces
•2 USB 2.0 hosts/masters
•Wi- i IEEE 802.11b/g/n on board
Extras
Restore factory defaults button
WPS
Dimensions (h x d x w)
19.5 x 6 x 23cm (9 x 2.4 x 9.7 in.)
AC Voltage
100-240 VAC (switched mode power supply)
Temperature
0°- 40°C (32 - 104 )
Humidity
20% to 80%
RESIDENTIAL GATEWAY MODEL TG799VN | 4
1. ECHNICAL SPECIFICA IONS

1.2 MANAGEMEN
•User riendly GUI via HTTP and HTTPS
•GUI-embedded Easy Setup wizard
•On demand Remote GUI assistence (helpdesk)
•Web-browsing Intercept (install / diagnostics)
•PC (wireless) Technicolor Gateway Setup Wizard
•TR-069 CPE WAN Management Protocol
•TR-104 Voice Service Provisioning
•TR-098 Internet Gateway Device Management
•TR-111 Home Network Device Management
•TR-140 Storage Service Provisioning
•TR-064 LAN Side Configuration
•Zero-Touch Auto-Provisioning
1.3 SERVICES
•Printer sharing
•Content sharing
- Samba ile Server
- UPnP Media Server
- DLNA DMS (certification ongoing)***
- Metadata support
•Remote HDD file access
•Embedded DECT: CAT-iq
•Parental control (Website Content iltering) (optional)
•Open architecture for 3rd party application development
1.4 FIREWALL SECURI Y
•Stateful Packet Inspection irewall (SPI )
•Customizable firewall security levels
•Instrusion detection and prevention (DoS, SYN lood, Ping of Death, raggle, LAND, Teardrop, etc.)
•Website URL and Content-based filtering
•DMZ
RESIDENTIAL GATEWAY MODEL TG799VN | 5

1.5 WIRELESS PERFORMANCE AND SECURI Y
•Wi- i IEEE 802.11b/g/n access point
•Wi- i CERTI IED®
•WPA™-Personal / WPA2™-Personal, WEP™
•Wi- i Multimedia (WMM®)
•Wi- i Protected Setup (WPS™)
•Up to 4 virtual SSID APs support
•Security and service segregation per SSID
•Dynamic rates switching for optimal wireless rates
•Manual/auto radio channel support
RESIDENTIAL GATEWAY MODEL TG799VN | 6
2. HARDWARE SE UP
FXS
PHONE ONT PC
WAN LAN
POWER

RESIDENTIAL GATEWAY MODEL TG799VN | 7
3. LED BEHAVIOR
Power LED
Colour
Green
Red
Orange
Off
State
Solid on
Solid on
Blinking
Description
Power on, normal operation
Power on, self-test failed, indicating device malfunction
Bootloader active (during upgrade)
Power off
Ethernet LED
Colour
Green
Off
State
Solid on
Blinking
Description
Ethernet connection, no activity
Ethernet activity
No Ethernet connection
Wireless LED
Colour
Green
Orange
Red
Red/Green
Off
State
Solid on
Blinking
Solid on
Blinking
Solid on
Blinking
Toggling
Description
No wireless activity, WPA(2) encryption
Wireless activity, WPA(2) encryption
No wireless activity, WEP encryption
Wireless activity, WEP encryption
No wireless activity, no security
Wireless activity, no security
Wireless client registration phase
WLAN disabled

RESIDENTIAL GATEWAY MODEL TG799VN | 8
Phone LED
Colour
Green
Off
State
Solid on
Blinking
Description
VoIP service up
VoIP activity
VoIP service down
Broadband LED
Colour
Green
Off
State
Solid on
Blinking
Description
DSL line synchronised
Pending DSL line synchronisation
No DSL line
Internet LED
Colour
Green
Red
Off
State
Solid on
Blinking
Solid on
Description
Internet connectivity, no activity
Internet activity
Internet connection setup failed
No Internet connection
Description
Client successfully registered via WPS
WPS registration ongoing
Error occurred
WPS Button LED
Colour
Green
Orange
Red
State
Solid on
Blinking
Blinking

RESIDENTIAL GATEWAY MODEL TG799VN | 9
USB LED
Colour
Green
Off
State
Solid on
Description
Device connected to the Residential Gateway’s USB port
No device connected to the Residential Gateway’s USB port
DECT LED
Colour
Green
Off
State
Solid on
Blinking
Description
DECT service up
DECT activity or registering DECT clients
DECT service down
Requirements
•Your computer must run one of the following operating systems:
Microsoft Windows 7 or higher
Microsoft Windows 7 x64 or higher
Microsoft Windows Vista (SP1) or higher
Microsoft Windows Vista x64 (SP1) or higher
Microsoft Windows XP SP2 or higher
Microsoft Windows XP x64 SP1 or higher
Microsoft Windows 2000 SP4
Mac OS X 10.4 (Tiger)
Mac OS X 10.5 (Leopard)
4. INS ALLA ION REQUIREMEN S

5.1 MOUN ING HE DOCKING S A ION
Proceed as follows:
1. On the bottom of your device, remove the overlay covering the DECT slot.
2. Insert the DECT cradle in the DECT slot.
3. The DECT cradle is now ready for use. You can now recharge the batteries of your DECT phone by placing
it in the cradle.
RESIDENTIAL GATEWAY MODEL TG799VN | 10
5. DEC SE UP

RESIDENTIAL GATEWAY MODEL TG799VN | 11
5.2 CONNEC ING HE DEC PHONE
Introduction
The Residential Gateway is equipped with a DECT base station allowing you to connect up to five DECT
phones. Before you can start using your DECT phone, you first have to pair it with your Residential Gateway.
Procedure
Proceed as follows:
1. Put the Residential Gateway in pairing mode. You can do either of the following:
Press the DECT button on the Residential Gateway until the DECT LED on the front panel starts flashing.
Via the Residential Gateway GUI.
1. On the Toolbox menu, click Telephony.
2. Under Pick a task, click DECT pairing.
2. Put your DECT phone in pairing mode.
5.3 REGIS ER H58 O G799vn
Proceed as follows:
1. The DECT phone prompts you to register your handset. If you do not see this message, open the Menu
and select Settings > Registration > Register Handset.
2. Press
3. The DECT phone prompts you to start registration on your base station.
4. Start DECT registration (also referred to as DECT pairing) on your base station. or more information,
consult the documentation of your base station.
5. Press
6. If your DECT phone prompts you to enter the system PIN, enter the system PIN of your base station. In
most cases, the system PIN will be “0000”.
7. Your DECT phone is now looking for your base station.
8. When successful, your DECT phone prompts you that your DECT phone is now registered.

Proceed as follows:
1. Connect the TG799vn to your broadband service.
2. Power on the TG799vn.
3. Connect your computer to the TG799vn.
4. Launch your Internet Browser.
5. Your Internet Browser will automatically redirect to TG799vn welcome page.
6. Click on Setup my Residential Gateway.
7. Easy Setup will appear, click Next to proceed.
RESIDENTIAL GATEWAY MODEL TG799VN | 12
6. EASY SE UP

8. Service Selection will appear , select your desired service and click Next.
9. Input your Internet Account User Name and Password , click Next to proceed.
RESIDENTIAL GATEWAY MODEL TG799VN | 13
Note
HSI(GPON)
•Internet with No VoIP HSI(GPON) & VoIP
•Internet with VoIP HIS(GPON),
+Public+ VoIP
•Internet with VoIP and Static IP for
Camera service.

10. Select your access selection , click Next to proceed.
11. Select your service selection , click Next to proceed.
RESIDENTIAL GATEWAY MODEL TG799VN | 14

12. Input your Voice Account Telephone Number, User Name and Password. Click Next to proceed.
13. Verify your configuration and click Start to apply.
RESIDENTIAL GATEWAY MODEL TG799VN | 15

14. Please wait for the wizard to complete the configuration.
15. Done! You have successfully setup TG799vn. Click Finish to close the wizard.
RESIDENTIAL GATEWAY MODEL TG799VN | 16

GUI
Proceed as follows:
1. Open your web browser.
2. Browse to http://dsldevice.lan or to the IP address of your TG799vn (by default: 192.168.1.254)
3. The TG799vn GUI appears.
odify username password
1. Click on eInternet to configure your user name and password.
RESIDENTIAL GATEWAY MODEL TG799VN | 17
7. MANUAL SE UP

2. Enter your Username and Password and click Connect.
odify VoIP Settings
1. To configure your VoIP settings. Click on Toolbox.
RESIDENTIAL GATEWAY MODEL TG799VN | 18

2. In Toolbox click on Telephony.
3. In Telephony click on Configure.
RESIDENTIAL GATEWAY MODEL TG799VN | 19

4. Input your VoIP account details and click Apply.
Wireless Connection
If you want to connect your computer using a wireless connection, you will need a Wi i-certified wireless
client adapter for each computer you want to connect wirelessly.
Before you can connect a computer to your wireless network you need to know the wireless settings that
are currently used by the TG799vn :
•The Network Name (SSID)
•The wireless key
TG TG799vn default SSID and Wireless key is printed at the bottom panel of the Gateway.
RESIDENTIAL GATEWAY MODEL TG799VN | 20
*Note
SIP URI: same details as username.
Display name: same details as username.
Abbreviated number: leave it blank.
Port: Select All to configure for both port
XS1 and XS2. Otherwise select
which port you would like to assign.
8. WIRELESS CONFIGURA ION