As standalone mode, all accessories be should enrolled to
the siren. Any detector triggered will activate the siren
immediately.
Standalone Alarm System-Standalone Mode
Connect Expandable Accessories to the Siren
Press enroll button of siren, the enroll backlight purple LED
light up, siren enters enrolling state, then trigger the
accessory ( for example: press arm button of remote control,
depart the transmitter and magnet of door sensor etc.),
the connection is successful after enroll LED light flashes once.
Press the enrolling button again to exit.
System will exit automatically after 20 seconds.
Note:
1. If accessory in delay zone, siren will alarm after 30 sec delay.
2. Connect outdoor siren to the indoor siren: Press enroll button of
outdoor siren, outdoor siren enters enrolling state, press emergency
button of remote control(Its remote already connect to indoor siren
before), the connection is successful after enroll button flashes once.
Control Panel Based Siren-Network Mode
In network mode, the siren is a control panel based system which
should be connected to the wireless alarm panel. The visual LED
backlight gently alerts you for arming/disarming status of the
alarm system. When alarm panel is alarming, it will hoot loudly
and the red LED flashes. User can quickly arm/disarm/stay arm
control panel system by pressing the touch buttons.
Connect Siren to the Alarm Panel
Press the Enroll Button of control panel, system beeps once and
the LED lights up in red. System enters enrolling status. Then
press the enroll button of Tutti. System beeps once, the LED light
flashes once, the enrollment is successful. If system beeps twice
and the LED light flashes once, the accessories have been enrolled
before. If three beeps are heard and LED light flashes once, the
storage is full. Press the enrolling button again to exit. System will
exit automatically after 20 seconds
Note!
1.Please do not trigger any other accessories during connecting with alarm panel.
2. As long as control panel been connected with siren, other accessories
no need to connect again.
Press and hold the enroll button until one
beep is heard, all accessories will be cleared.
Clear All Enrolled Accessories
In order to make sure the position of siren is well connected
with control panel, please test communication distance
before install.
Test the distance between siren and control panel
If the door is open, when you arm the system, Tutti will beep in 3
times to remind user to close the door. User can force to arm the
system by pressing the "Arm" button again within 5 seconds.
Supervision for Door Sensor
