MaxLite AP Series User manual

Operating Instructions AP Series
MaxLite Air Purifier (AP215SF1)
®
Replacing the Filter (AP-H13)
When the reset button indicator flashes, the user is
reminded to replace the filter.
Resetting
When the product works, the filter replacement
indicator flashes and the buzzer sends out a "ding,
ding" alarm to remind the user to replace the
filter, but the purifier can still work normally.
Please turn off the instrument and unplug
the power plug before replacing the filter. After
replacing the filter, if the replacement
indicator still flashes after starting up, please
press the reset button for 3 seconds to reset
the filter. The filter replacement indicator is
turned off and the filter reset is completed.
Note: Please remove the plastic packaging on the
filter before putting it into air purifier unit.
Operation Steps:
1. Instrument reminds to replace filter
Resetting
2. Turn off the power supply, stop the purifier, and
then unplug the power plug.
3. Press the bottom cover with your fingers and
screw it out in the unlocking direction while
taking out the bottom cover upward.
4. Remove the filter inside the purifier and
replace the filter.
5. Remove the packaging material of the new filter.
© Copyright 2023. MaxLite, Inc. All Rights Reserved.
340 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: [phone] Fax: [phone] Email: [email protected]
Page: 1
REV: 02/06/23

Operating Instructions AP Series
MaxLite Air Purifier (AP215SF1)
®
Replacing the Filter (AP-H13) Continued
6. Put the filter into the purifier
7. Put in the filter again, press the indicator button
to put in the bottom cover and tighten it
8. After replacing the filter, plug in the power plug
and press the reset button for 3 seconds to
reset the instrument.
Resetting
When it’s unused for a long time:
Unplug the power plug. (Because the instrument
also consumes power in standby state.) Thoroughly
dry the interior.
Store the instrument in a dry and ventilated place for
safekeeping. (Storing it flat or upside down may
cause equipment failure)
Reference time for replacement of filter:
The filter of this product is Pre-filter + HEPA +
activated carbon filter. The filter cannot be washed
with water and is easy to damage. Please don't
press hard. Generally, the service period is six
months.
The above time is only a reference time, and users
can change it in advance according to the actual
use environment.
Please turn off the instrument and cut off the power
plug before replacing the filter.
© Copyright 2023. MaxLite, Inc. All Rights Reserved.
340 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: [phone] Fax: [phone] Email: [email protected]
Page: 2
REV: 02/06/23