MaxLite PhotonMax Series User manual

Operating Instructions PhotonMax Series
MaxLit MaxLit PhotonMax 315 C ramic M tal Halid Singl Lamp Fixtur
RISK OF ELECTRIC SHOCK:
• Turn power off before inspection, installation or removal.
• Protect lamp from direct contact with liquids to avoid breakage from thermal shock.
RISK OF FIRE:
• Keep combustible materials away from lamp during operation.
UNEXPECTED LAMP RUPTURE MAY CAUSE INJURY, FIRE OR PROPERTY DAMAGE
• Do not exceed rated ballast voltage.
• Do not use lamp if outer glass is scratched or broken.
• Do not use beyond rated life.
• Do not turn on lamp until fully installed.
• Use only with a fixture and ballast rated for this product.
• Electrically insulate any metal to glass support in fixture.
LAMP MAY SHATTER AND CAUSE INJURY IF BROKEN
• Do not use excessive force when installing lamp.
• Dispose of lamp in an enclosed container.
• Wear safety glasses and gloves when installing lamp.
LAMP CONTAINS MERCURY
• Manage in accordance with disposal laws.
WARNING:
• R "WAR I G: These lamps can cause serious skin burn and eye inflammation from short wave ultraviolet radiation if outer
envelope of the lamp is broken or punctured. Do not use where people will remain for more than a few minutes unless adequate
shielding or other safety precautions are used. Certain lamps that will automatically extinguish when the outer envelope is broken
or punctured are commercially available." This lamp complies with FDA radiation performance standard 21 CFR subchapter J.
(USA:21 CFR 1040.30 Canada: SOR/DORS/80-381)
Metal halide lamps contain mercury. MaxLite strives to preserve the environment and make efficient use of resources. Please
refer to your local environmental laws regarding disposal and recycling of mercury containing lamps. For more information,
please go to www.lamprecycle.org.
WARNING:
• Carefully read the warnings below before using or working with the product!
• Always adhere to the local rules and regulations when installing or using the fixture.
• Do not use the fixture when either its lamp or its power cord are damaged. Replace the power cord only with original certified cords.
• Do not expose fixture to:
- Condensing humidity, heavy mist, fog or direct spray.
- Temperatures outside the specified range.
- Dust and contamination.
• Always disconnect the fixture from mains before performing any task on it.
• Always allow for a cool down period of at least 30 minutes before touching the lamp or reflector. Touching the lamp or reflector
when the lamp is lit or immediately afterwards will result in severe burns!
• Do not use the fixture near flammable, explosive or reactive substances. The lamp and reflector of the fixture become very
hot during use.
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [email protected]
Page: 1
REV: 05/04/18
®
General Sa ety Inormation
READ AND F LL W ALL SAFETY INSTRUCTI NS
Picture is for illustration
purposes only. Your model
may vary.

!"#$%&'$%$()*"+ !"#$"%&'('&) !"#$"%&'(*&)
+,-./0123-,4. '*)#*5)10 **)#*661
789:-0%;.<:.8=>0?"@A
B-,;-C840DCE.
!:3F.G748C-C280123-,4.
789:-0!2H.;0%,=-2;
D"I
J:-9:-0%;.<:.8=>
J9.80KC;=:C-0123-,4.
L,M.0K;.F-0+,-C2
NOOC=C.8=>0
P5))
P'Q6
RS*
(0$C8:-.F
5#T0U1
R)QSV
P')
'')0"W
()GT)
WARNING:
• Do not use sulfur vaporizers or water misters close to your fixture. Sulfur and calcium deposits on your reflector will decrease
its efficiency.
• ever touch the lamp or the inside of the reflector with bare hands as
this will cause damage to the lamp or reflector.
• Input power cord MUST be secured and routed away from the
luminaire enclosure and reflector, via the mounting cable nearest the
ballast at least every 4 inches.
The product is meant for use in climate rooms. The product may be
used in damp environments. Do not use product in wet environments
or outdoors.
Mod l:
Operating Instructions PhotonMax Series
MaxLit MaxLit PhotonMax 315 C ramic M tal Halid Singl Lamp Fixtur
®
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [email protected]
Page: 2
REV: 05/04/18

Installing the ixture
WARNING:
• Avoid coiled cords. Coiled cords may lead to electromagnetic interference.
• Input power cord MUST be secured and routed away from the luminaire enclosure and
reflector, via the mounting cable nearest the ballast at least every 4 inches.
• Always install the lamp before connecting the fixture to the mains. Never use the fixture
without a lamp or reflector!
• Ensure the local cabling can support the voltage and current requirements of the fixture.
1. Install the lamp in the fixture.
2. Connect to the mains. (Make sure the plug used is compatible with your socket.)
Hang light with optional rope..
Inspection, maintenance and repair
WARNING:
• Disconnect the product from mains before performing any maintenance or repairs.
• Do not open or disassemble the fixture, it contains no serviceable parts inside. Opening the fixture can be dangerous
and will void the warranty.
• Always allow for a cool down period of at least 30 minutes before touching the lamp or reflector.
CAUTION:
• Do not clean the fixture with detergents, abrasives or other aggressive substances.
• Do not touch the inside of the reflector and do not use water, abrasives or detergents to clean it. This will damage the
reflective surface.
• Wait 20 minutes before activating the fixture after maintenance work has been conducted.
• Regularly check the fixture for dust or dirt buildup. Clean if necessary.
• Contamination may cause overheating and decreased performance.
- Clean the inside of the reflector only with a soft dry cloth.
- Clean the electric ballast and outside of the fixture using a dry or damp cloth.
• Check the lamp monthly for discolorations or black markings. Always replace a damaged lamp.
• Regularly check the wiring of the product to ensure it’s undamaged.
Placement and replacement o the lamp
CAUTION:
• Do not touch lamp with bare hands as this will damage the lamp. Always use a fabric glove to handle the lamp.
NOTE: The lamp must be replaced every year or after 5000 lighting hours, whichever one comes first.
• Hold the lamp with a fabric glove to prevent it from falling. Use a protective glove if the lamp is damaged.
Storage and disposal
• Store the fixture in a dry, clean environment.
• The product must not be discarded as unsorted municipal waste, but must be collected separately for the purpose of treatment,
recovery and environmentally sound disposal.
CAUTION:
The lamps are chemical hazardous waste and must be delivered to the designated authorities.
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [email protected]
Page: 3
REV: 05/04/18
Operating Instructions PhotonMax Series
MaxLit MaxLit PhotonMax 315 C ramic M tal Halid Singl Lamp Fixtur
®

MaxLite Inc. warrants its products for a minimum period of ONE (1) year from the date of original purchase from
MaxLite or its authorized distributor/dealer (the “Warranty Period”), as follows: If a Product fails to operate during the
Warranty Period as a result of defects in materials or workmanship, MaxLite will, at its option, repair it, replace it with
the same or like Product.
Please refer to Maxlite’s website (at http://maxlite.com/resources/warranties) for the complete
terms and conditions of our warranty.
Limitation of Liability
THE FOREGOI G WARRA TY IS EXCLUSIVE, A D IS THE SOLE REMEDY FOR A Y A D ALL CLAIMS,
WHETHER I CO TRACT, I TORT OR OTHERWISE ARISI G FROM THE FAILURE OF PRODUCT A D IS I
LIEU OF ALL OTHER WARRA TIES, EXPRESS OR IMPLIED, I CLUDI G ALL WARRA TIES OF
MERCHA TABILITY OR FIT ESS FOR A PARTICULAR PURPOSE, WHICH WARRA TIES ARE HEREBY
EXPRESSLY DISCLAIMED TO THE EXTE T PERMITTED BY LAW A D, I A Y EVE T, SHALL BE LIMITED TO
THE WARRA TY PERIOD SPECIFIED ABOVE. THE LIABILITY OF MAXLITE SHALL BE LIMITED TO THE TERMS
OF THE EXPRESS WARRA TY SET FORTH HEREI . I O EVE T WILL MAXLITE BE LIABLE FOR A Y
SPECIAL, I CIDE TAL OR CO SEQUE TIAL DAMAGES I CLUDI G, WITHOUT LIMITATIO , DAMAGES
RESULTI G FROM LOSS OF USE, PROFITS, BUSI ESS OR GOODWILL, LABOR COSTS, REMOVAL OR
I STALLATIO COSTS, DECREASE I THE LIGHT OUTPUT OF THE LAMP, A D/OR DETERIORATIO I THE
LAMP’S PERFORMA CE, WHETHER OR OT MAXLITE HAS BEE ADVISED OF THE POSSIBILITY THEREOF.
U DER O CIRCUMSTA CES SHALL MAXLITE’S E TIRE LIABILITY FOR A DEFECTIVE PRODUCT EXCEED
THE PURCHASE PRICE OF THAT PRODUCT. WARRA TY SERVICES PROVIDED U DER THESE TERMS A D
CO DITIO S DO OT E SURE THE U I TERRUPTED OPERATIO OF PRODUCTS; MAXLITE SHALL OT BE
LIABLE FOR DAMAGES CAUSED BY A Y DELAYS I VOLVI G WARRA TY SERVICE.
This Limited Warranty gives you specific legal rights and you may also have other rights that may vary from state to
state. Because some states or jurisdictions do not allow the exclusion or limitation of liability for consequential or
incidental damages, this limitation may not apply to you.
Lamp and R fl ctor Warranty Information
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [email protected]
Page: 4
REV: 05/04/18
Operating Instructions PhotonMax Series
MaxLit MaxLit PhotonMax 315 C ramic M tal Halid Singl Lamp Fixtur
®

MaxLite Inc. warrants its products for a minimum period of THREE (3) year from the date of original purchase from
MaxLite or its authorized distributor/dealer (the “Warranty Period”), as follows: If a Product fails to operate during the
Warranty Period as a result of defects in materials or workmanship, MaxLite will, at its option, repair it, replace it with
the same or like Product.
Please refer to Maxlite’s website (at http://maxlite.com/resources/warranties) for the complete
terms and conditions of our warranty.
Limitation of Liability
THE FOREGOI G WARRA TY IS EXCLUSIVE, A D IS THE SOLE REMEDY FOR A Y A D ALL CLAIMS,
WHETHER I CO TRACT, I TORT OR OTHERWISE ARISI G FROM THE FAILURE OF PRODUCT A D IS I
LIEU OF ALL OTHER WARRA TIES, EXPRESS OR IMPLIED, I CLUDI G ALL WARRA TIES OF
MERCHA TABILITY OR FIT ESS FOR A PARTICULAR PURPOSE, WHICH WARRA TIES ARE HEREBY
EXPRESSLY DISCLAIMED TO THE EXTE T PERMITTED BY LAW A D, I A Y EVE T, SHALL BE LIMITED TO
THE WARRA TY PERIOD SPECIFIED ABOVE. THE LIABILITY OF MAXLITE SHALL BE LIMITED TO THE TERMS
OF THE EXPRESS WARRA TY SET FORTH HEREI . I O EVE T WILL MAXLITE BE LIABLE FOR A Y
SPECIAL, I CIDE TAL OR CO SEQUE TIAL DAMAGES I CLUDI G, WITHOUT LIMITATIO , DAMAGES
RESULTI G FROM LOSS OF USE, PROFITS, BUSI ESS OR GOODWILL, LABOR COSTS, REMOVAL OR
I STALLATIO COSTS, DECREASE I THE LIGHT OUTPUT OF THE LAMP, A D/OR DETERIORATIO I THE
LAMP’S PERFORMA CE, WHETHER OR OT MAXLITE HAS BEE ADVISED OF THE POSSIBILITY THEREOF.
U DER O CIRCUMSTA CES SHALL MAXLITE’S E TIRE LIABILITY FOR A DEFECTIVE PRODUCT EXCEED
THE PURCHASE PRICE OF THAT PRODUCT. WARRA TY SERVICES PROVIDED U DER THESE TERMS A D
CO DITIO S DO OT E SURE THE U I TERRUPTED OPERATIO OF PRODUCTS; MAXLITE SHALL OT BE
LIABLE FOR DAMAGES CAUSED BY A Y DELAYS I VOLVI G WARRA TY SERVICE.
This Limited Warranty gives you specific legal rights and you may also have other rights that may vary from state to
state. Because some states or jurisdictions do not allow the exclusion or limitation of liability for consequential or
incidental damages, this limitation may not apply to you.
Ballast Warranty Information
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [email protected]
Page: 5
REV: 05/04/18
Operating Instructions PhotonMax Series
MaxLit MaxLit PhotonMax 315 C ramic M tal Halid Singl Lamp Fixtur
®