MaxxHome 20722 Manual

Werkplaatskachel
9 Kw
Model: 20722

1
User’s Manual and
Operating Instructions
FAN HEATER
READ INSTRUCTIONS CAREFULLY:
Read and follow all instructions. Place instructions in a safe place for future
reference. Do not allow anyone who has not read these instructions to assemble,
light, adjust or operate the heater.
1.1 This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
1.2 WARNING: In order to avoid overheating, do not cover the heater.
1.3 Children of less than 3 years should be kept away unless continuously supervised.
1.4 Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that
it has been placed or installed in its intended normal operating position and they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the
appliance or perform user maintenance.
1.5 CAUTION - some parts of this product can become very hot and cause burns. Particular attention
has to be given where children and vulnerable people are present.
1.6 The heater must not be located immediately below a socket-outlet.
1.7 Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
1.8 If the supply cord is damaged, it must be replaced by the manufacture, its service agent or similarly
qualified persons in order to avoid a hazard.
2. Introduction
2.1 Depending on the power cord type his fan heater may be used only in household, warehouses and
workshops, building sites or greenhouses depending. It incorporates a thermostat and a self-resetting
thermal cut-out to control the heating elements. The thermostat feels the air temperature and controls the
surrounding temperature. The fan motor is not controlled by thermostat and it keeps on working when the
thermostat cuts off the heating element. The self-resetting thermal cut-out will switch off the heater to
ensure the safety when overheating.
2.2 When using the heater for the first time, you may notice a slight emission of smoke. This is quite
normal and it stops after a short time. The heating element is made of stainless steel and was coated with
protection oil by production. The smoke is caused by the left oil when heated.

2
3. Technical specifications
Model 20722
Waterproof Class IP24
Voltage 220-240V~ 50Hz
required power 9000W
Setting 52/4500/9000W
3.1 Housing of steel plate and coated by heat-resistant powder.
3.2 Supplied complete with cord and plug.
4. Description of Control Panel
4.1 Left Knob: selector with heat setting
4.2 Right Knob: Thermostat dial
5. Special safety regulations
5.1 When using electrical appliance basic precautions should always be followed including below:
5.1.1 The fan heater is not suitable for use outdoors in damp weather, in bathrooms or in other wet or
damp environments.
5.1.2 Please note that the fan heater can become very hot and should, therefore, be placed at a safe
distance from flammable objects such as furniture, curtains and similar.
5.1.3 Do not cover the fan heater.
5.1.4 The fan heater must not be located immediately below a socket outlet.
5.1.5 Do not connect the fan heater using an on/off timer or other equipment which can automatically
switch the device on.
5.1.6 The fan heater must not be placed in rooms where flammable liquids or gases are used or stored.
5.1.7 If an extension cord is used, it must be as short as possible and always be fully extended.
5.1.8 You must not connect other appliances to the same mains socket as the fan heater.
5.1.9 Do not use this fan heater in the immediate surroundings of a bath, a shower or a swimming pool.
5.1.10 If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
5.1.11 Make sure heater is always under surveillance and keep children and animals away from it.
5.1.12 Do not place the appliance on moving vehicles or somewhere easy to be tipped over.
5.1.13 When you don’t use the appliance for a long time, unplug the appliance. Don’t leave the heater for
a considerable amount of time when in use. Pull the plug straight out, never remove the plug by pulling on
the cord.
5.1.14 Keep the heater far from curtain or places where the air inlet can easily be blocked.
5.1.15 The power coupler is waterproof when not in use. In order to prevent possible electric shock or
leakage current, never use the appliance with wet hand or operate the appliance when there is water on
the power cord.
5.1.16 Do not dispose of electrical appliances as unsorted municipal waste, use separate collection
facilities. Contact you local government for information regarding the collection systems available. If

3
electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging your health and well-being.
5.1.17 This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
5.1.18 Children should be supervised to ensure that they do not play with the appliance.
6. Using Instructions
6.1 Position the fan heater so that it stands upright on a firm surface and at a safe distance from wet
environments and flammable objects.
6.2 Connect the fan heater to the mains.
6.3Set the thermostat knob to the MAX and let the heater operate with full power.
6.4 The fan heater will switch on when the heating selector is set to one of the power settings.
6.5 Once the room reaches the required temperature, heating element will stop working but fan also
working .Once the temperature decreased, the heating element will be working. The fan heater now starts
and stops automatically and thus keeps the room temperature constant.
6.6 Before switch off the heater, please turn the thermostat to MIN position and turn the switch to fan
position, let the appliance cool down for two minutes then turn off the heater and pull out the plug.
7. Cleaning and Maintenance
7.1 Before cleaning the appliance, disconnect it from the socket and let it cool down. The enclosure is
easily to get dirty, wipe it often with soft sponge. For every dirty parts, wipe with a sponge dipped in <50°C
water and mild detergent, then dry the heater enclosure with clean cloth. Be careful not to let the water
enter the appliance inner. Don’t splash water onto the heater, never use solvent like gasoline etc. to clean
the heater, in order to protect the enclosure.
7.2 Clean the cord and plug, dry and pack it in a plastic bag.
7.3 When you store the heater, let it cool down first, keep it dry. Then cover it with a plastic bag, put in a
packing box and store it in a dry, ventilated place.

4
8. Trouble shooting:
You can solve many common problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the service centre.
Problem
Possible cause Treatment
The heater does not
operate, even when it
is plugged in and the
switch, thermostat is
switched on.
The plug is loose,
bad connection
Pull out the plug, check the connection of
the plug and socket. Then connect again.
No power in socket
outlet
Insert the plug in a proper socket
The heating element
glowing
The input voltage is
too high or too low
Use power supply according to the rating on
the label
The air inlet grill is
blocked
Keep the heater far way from articles like
curtain, plastic bag, paper and other things
which can cover the inlet or can be easily
cover on the air inlet
The appliance didn’t
heat up, only
ventilator worked
The switch was not
put at heating setting
Turn the switch to heat setting
The thermostat
operated
Turn the thermostat and listen if there is
open/close voice. If there is no click and the
thermostat is not damaged, the heater will
automatic switch on when the appliance
cooled down
The self retting
cut-out operated
Turn the heater off and inspect the blockage
of inlet or outlet. Disconnect the plug and
wait at least 10 minutes for the protection
system to reset before attempting to restart
the heater.
Abnormal noise The appliance is not
stands upright
Put the heater on a level surface
Disposal
Environmental Protection
Waste electrical production should not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or retailer for recycling advice.

TELEFOONSERVICE:
[phone]
Maandag tot zaterdag - 9u.-18u.
De telefoon kosten kunnen variëren afhankelijk
van uw mobiel abonnement.
ASSISTANCE TÉLÉPHONIQUE:
[phone]
Du lundi au samedi de 9h à 18h
Les frais de téléphone peuvent varier en fonction
de votre abonnement mobile.
TELEFON-SERVICE:
[phone]
Montag bis Samstag von 9 bis 18 Uhr
Die Telefonkosten können je nach
Mobilfunkabonnement variieren.
TELEPHONE SUPPORT:
[phone]
Monday to Saturday - 9 am - 6 pm
Phone charges may vary depending on your
mobile subscription.
ONS MAXXTOOLS TEAM HELPT JE MET:
nVragen over je bestelling
nKlachten
nOnderdelen en handleidingen
Heb je vragen of klachten contacteer
ons en we helpen je graag verder.
NOTRE EQUIPE MAXXTOOLS VOUS AIDERA
VOLONTIÈRE AUX CAS SUIVANTS:
nQuestions sur votre commande
nRéclamations
nPièces et manuels
Si vous avez des questions ou des plaintes,
s’il vous plaît contactez-nous et nous serons
heureux de vous aider.
UNSER MAXXTOOLS TEAM HILFT IHNEN
GERNE BEI:
nFragen zu Ihrer Bestellung
nReklamationen
nTeile und Handbücher
Wenn Sie Fragen oder Beschwerden haben,
wenden Sie sich bitte an uns.
Wir helfen Ihnen gerne weiter.
OUR MAXXTOOLS SERVICE TEAM HELPS
YOU WITH:
nQuestions about your order
nComplaints
nParts and manuals
If you have any questions or complaints,
please contact us and we will be happy
to help you.
Maxxtools
Grotstraat 36 - 3990 Peer
[email protected]
www.maxxtools.be