MEDI RENT CTC-7 User manual
© 2023 Medi-Rent Pty Limited
2
FIRST TIME USE:
Use bottled water provided.
Unscrew the water tank lid and ll the tank
to MAX.
Approx. 30 secs after you press the play
button the garment will ll with water.
Top up the tank whilst the device is running.
Approx. 450mL.
OVERFILLING CAN LEAD TO SPILLAGE!
4
Connect air and water hosing to device
only, making sure you hear a click when
connecting.
Place the device somewhere easily
accessible, ideally on the same level as the
garment e.g. a side table. Leave at least
30cm clearance around the device for
unrestricted air ow.
1
Plug the power lead in to both the wall and
device, ensuring it is not a trip hazard.
3
CTC-7 Quick Set-up Guide: knee
This guide is intended as a quick reference once the user manual has been read in-full
Medi-Rent Pty Limited
ABN: 37 603 454 360
AU PH: 1300 726 666
HEAD OFFICE:
Unit 1, 61 Beauchamp Rd
Matraville NSW 2036
Unit 3, 93 Riverside Avenue
Werribee VIC 3030
Unit 3,8 Emplacement Crescent
Hamilton Hill WA 6163
NZ PH: 0800 725 555
9F Lady Ruby Drive
East Tamaki
Auckland 2013
NEW ZEALAND
www.medirent.com.au
www.medirent.co.nz
6
Connect air and water hosing to the
garment, making sure you hear a click when
connecting.
5
Lay the garment at under your knee ensuring the tubing is not kinked or twisted.
Wrap the garment around your knee. Use the adhesive strips to hold the garment in place.
Additional strips can be used to increase rmness of the garment.
8
The screen will display CTC-7 modes of
therapy.
SET-up continued
11
Time: Rotate the dial to highlight the time
setting, press the dial.
The menu will allow you to choose between
Manual time and Preset time.
Manual time range 5 - 60min.
Preset time options Run/Rest 20/20, 20/40,
30/30, 30/60.
Press back arrow to return to settings.
Press play button to start therapy.
9
Turn the dial to highlight selection. Press the dial to select COLD therapy. For swifter cooling, run the device on COLD therapy mode 15min prior to applying the
garment to your body. Stop device to don garment and restart COLD therapy.
Longer exposure to COLD will increase cooling effect. You may extend the duration of COLD
therapy if your skin has not reached desired cooling level. Check skin temperature with your
hand as the area covered by the garment may have altered sensation.
7
Turn the device on.
au PH: 1300 726 666 NZ PH: 0800 725 555
Medi-Rent Pty Limited ABN: 37 603 454 360 Unit 1, 61 Beauchamp Rd Matraville NSW 2036 Australia 9F Lady Ruby Drive East Tamaki Auckland 2013 New Zealand [email protected] www.medirent.com.au © 2023
USER MANUAL
How to use
6
※Use “Clause 5. Installation” as your reference to install CTC-7 in your intended environment.
1) When you turn on the power switch located on the side of this device, the mode selection
screen will appear.
2) On the mode selection screen, rotate the knob wheel counterclockwise or clockwise to
select the mode to be used. Select the mode to be used and press the knob wheel to move
to the standby screen of the selected mode.
3) Finish setting the mode to be used and press the start/stop button to activate the mode
based on the settings.
* Use “6-1, 6-2 Setting” as your reference to set each mode.
* While this device is in operation, the settings cannot be changed.
To change the settings, stop this device from operating.
* To stop this device from operating, press the start/stop button and press the knob wheel.
SD USB
FLOW
SD USB
FLOW
SD USB
FLOW
SD USB
FLOW
SD USB
FLOW
SD USB
FLOW
25
10
To commence treatment on standard
settings, press play button (top right
of the dial).
Please seek advice from your treating health professional as to whether this device is
suitable for use in consideration of your specic presentation and full medical history.
Please refer to the owner manual for how to adjust settings for heat or contrast therapy as
well as contraindications for using this device.
caution
Standard sengs for COLD therapy:
Time: 20 min on; 20 min off cycle
Repeated until device is turned off.
Temperature: 6°C
Pressure: 4
have questions?
WARNING - Store your garment correctly between uses to avoid water leak!
Call us on AU PH 1300 726 666 or NZ PH 0800 725 555
Take note how to avoid water leakage between uses:
* When your therapy session is complete please disconnect the hosing from the unit.
* Store the garment, bladder, and hosing in bag provided.
* Keep the device in an upright posion at all mes during use, transport, and when it is switched off.
✔✖
*Potenal slip hazard or damage to personal eects*
Temperature and Compression:
Select setting to adjust. Rotate the dial to
adjust the value and press the dial to save the
setting.
Press the back arrow to return to settings.
Press play button to start therapy.
TIPS
To stop therapy press the play/stop button
and turn the device off.
1. On the mode selection screen, rotate the dial to highlight Cold or Heat Therapy, and press
the dial to select the desired mode.
2. The screen will change to the settings display for the mode selected. Within the settings
menu, you can set the time, temperature and pressure level.
3. Rotate the dial counterclockwise or clockwise to highlight the setting you would like to
adjust. Select the ‘Time’, ‘Temperature’, or ‘Pressure’ setting by pressing the dial.
A setting parameter screen will appear on the display.
Rotate the dial counterclockwise or clockwise to adjust the levels. Press the dial to save
the settings, and press the back button to return to the setting screen.
• On the setting screen, press the start/stop button to start treatment.
Cold and Heat Therapy Sengs
21
To change COLD therapy settings, press central dial when viewing current sengs to access opons menu for the following:
Other MEDI RENT Personal Care Product manuals
