Melissa & Doug Wooden Doll High Chair 9382 User manual

We care about your comments. Please call us!
1-800-284-3948
www.MelissaAndDoug.com
2013 Melissa & Doug, LLC, P.O. Box 590, Westport, CT 06881
c
CHOKING HAZARD- Small parts.
Not for children under 3 years.
WARNING: !
WARNING:
Adult assembly required.
!
9382 Wooden Doll High Chair
Item #
Assembly Instructions
9382
This doll chair is not
intended for child seating.
Use only for toy dolls.

(A) 1 piece
(B) 1 piece
(C) 1 piece
9382 Wooden Doll High Chair
PARTS
HARDWARE
(Shown Actual Size)
Hex Head Screw
Barrel Nut
Hex Key
(D) 1 piece
(E) 2 pieces
(F) 1 piece
(G) 1 piece
(H) 1 piece
12 pieces
6 pieces
1 piece

How to correctly install
Barrel Nuts
Press a Barrel Nut into the hole in the
part making sure that the "+" pattern
is facing out.
"+" pattern
Using a standard screwdriver, turn
the Barrel Nut until the threaded hole is facing
outward to accept the screw shown below.
Threaded hole
of the Barrel Nut
9382 Wooden Doll High Chair
(Images on this page are
for example only.)

A
B
Hex Head
Screws
NOTE: The longer side
of the foot support should
be facing out.
Attach seat(A) to front legs(B)
with 2 Hex Head Screws.
Make sure the legs are facing
the correct direction, noted
below.
C
D
Barrel Nuts
Hex Head
Screws
Hex Head
Screws
9382 Wooden Doll High Chair
STEP 2
Assembled Step
Assembled Step
Attach the armrests(C & D) as
shown using 2 Barrel Nuts and then
2 Hex Head Screws as shown.
Refer to the instructions about
how to properly install Barrel Nuts.
STEP 1

E
Hex Head Screws
F
Barrel Nuts
NOTE: The direction of the
slanted edge on the Back(F)
9382 Wooden Doll High Chair
STEP 3
STEP 4
Assembled Step
Assembled Step
Attach 2 spindles(E) as shown
using 2 Hex Head Screws.
Attach the Back(F) to the Seat
and Armrests as shown using 2
Barrel Nuts first, then 2 Hex Head
Screws as shown.
Hex Head
Screws

G
Hex Head Screws
Barrel Nuts
H
NOTE: Slide on
with curve side out
NOTE: The slanted edge on the
Rear Legs(G) should match the
slanted edge of the Back(F).
9382 Wooden Doll High Chair
STEP 5
STEP 6
Assembled Step
Assembled Step
Attach the Rear Legs(G) as
shown using 2 Barrel Nuts first
then 4 Hex Head Screws.
Note: The Spindles already have
threaded inserts.
Finally, slide on the Tray(H) as
shown. The Tray has a bump on
the bottom to keep it in place.
Removing or inserting the Tray
may require a slight lifting to
fit over the bump.
Enjoy your completed
Wood Doll High Chair.
4 pieces needed
2 pieces needed