Mellerware LIvenza User manual

PLEASE READ ALL INSTRUCTIONS BEFORE USE
2 year guarantee
Livenza Milk Frother
Model:
29400
550W
complies with
INTERNATIONAL
IEC60335
SAFETY SPECIFICATIONS
MW_29400.indd 1 2013/01/16 01:59:53 PM

Important safeguards:
When using electrical appliances, basic safety
precautions should always be followed Including the
following:
1. Read all the instructions.
2. To protect against electrical hazards, do not
immerse the appliance, or its power cord in
water or any other liquid.
3. This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
4. Unplug the appliance from the wall socket
before undertaking any cleaning task.
5. If the power cord is damaged, it must be
replaced by an authorised service centre.
6. Do not use the appliance outdoors.
7. Do not let the power cord hang over the edge
of a table or counter, or allow it to touch any
hot surface.
8. Do not place the appliance on or near a hot gas
or electric burner, or in a heated oven.
9. Extreme caution must be used when moving
the appliance while it contains hot milk.
10. To disconnect, press the on/off button (the pilot
light will switch off), then remove the plug from
the wall socket.
11. CAUTION: This appliance generates heat during
use. Proper care must be taken to prevent
the risk of fire or injury.
12. Do not leave the appliance unattended while it
is in use.
13. This appliance is for household use only. Do not
use the appliance for anything other than its
intended use.
To froth cold milk:
1. Pour the desired amount of fresh milk into the
jug (MAX 300ml).
2. Close the lid.
3. Insert the plug into the wall socket. Press and
hold the on/off button until the blue pilot light
illuminates, then release the on/off button.
4. The milk will now begin to froth, please switch
Description:
1. Lid
2. Handle
3. Motor housing
4. Base
5. Jug
6. On/off button
7. Frothing mechanism
MW_29400.indd 2 2013/01/16 01:59:54 PM

the appliance off once the froth has reached the
desired consistency.
5. You can use the appliance again once it has
cooled down (after about 5 minutes).
To heat and froth milk:
1. Pour the desired amount of fresh milk into the
jug (MAX 130ml) .
2. Close the lid.
3. Insert the plug into the wall socket. Press the
on/off button, the red pilot light will illuminate.
4. The milk will now begin to heat and froth, the
appliance will switch off automatically.
5. You can use the milk frother again once the
appliance has cooled down (after about 5
minutes).
Cleaning:
1. Always ensure that the appliance is unplugged
from the wall socket and that it has cooled down
completely before undertaking any cleaning
task.
2. After using the appliance, pour clean water and
some dish washing liquid into the jug and allow
it to stand for a few minutes, then rinse the ap-
pliance and wipe it with a clean dry cloth.
CAUTION:
* Do not immerse the appliance in water or any
other liquid.
* Do not use any abrasive cleaning agents, or any
sharp objects (such as knives or hard brushes)
when cleaning this appliance.
Environment:
When you are ready to dispose of the appliance,
remove the plug from the wall socket, and cut the
power cord. Keep the appliance and its parts out
of the reach of children. Deliver the appliance to an
approved collection point for small appliances.
MW_29400.indd 3 2013/01/16 01:59:54 PM

MW_29400.indd 4 2013/01/16 01:59:55 PM