Menumaster MCMOC24 User manual

RAIL INSTALLATION FOR THE MCMOC24
IMPORTANT: PLEASE READ CAREFULLY
• TheMcDonald’sOnCueRailKithasbeendesignedspecicallyforthe
McDonaldsMcMOC24andshouldnotbeusedwithothermodels.
• Pleasehandlerailscarefullyandavoiddropping,banging,twisting,
bendingorforcefulimpactwithmagneticsurface.Themagnetshave
verystrongattractionforceandcanbedamagedorcausedamageif
suddenlyattractedtoamagneticsurface.
• Donotattempttodislodgethemagnets
• Beforeattemptingtoinstallyourrails:
• Inspecttheovencavitytoensurethatthereare2‘raildimples’oneach
ofthecavity’ssidewalls.
• Thesedimplesarethereto‘receive’the‘alignmentpegs’foundon
eachoftherails(seediagramtotheright)
• Wheninstallingtherails:
• itisimportanttoalignthepegswiththedimplestoensureproper
installation.
• Onceinstalled,railsshouldsitatandushagainstthesideofthe
oven,withthemagnetsholdingtherailsinplace.
• Itisalsoimportanttoinstalltherails‘rightsideup’.
• Bycarefullyfollowingtheinstructionsbelowyoucanbesurethatthe
railshavebeeninstalledcorrectlyfortroublefreeandsafeoperation.
• Pleasepaycarefulattentiontothecleaninginstructionsfoundimmedi-
atelyfollowingtheinstallationinstructionsbelow.
• Railsshouldnotbeimmersedinwaterandnocausticcleaningchem-
icalsaretobeused.Wipecleanwithamoistcloth,dryandre-install
accordingtotheinstructionsbelow
⚠SAFETY WARNING
The rails include Neodymium magnets and
need to be kept a minimum of 4” (102mm)
away from objects that may be affected
by magnetism, these include mechanical
watches, pacemakers, CRT monitors, credit
cards, diskettes and other magnetically
stored media.
The magnets are plated with a 3-layer
protective copper-nickel coating. During
normal use the plating should not wear
or breakdown, however if the plating is
scratched this could expose the magnet to
corrosion & rust.
Take care not to expose the magnet to
objects that may scratch the plating.
Alignment Peg
Rail
Installation Instructions
(Please read the IMPORTANT instructions above before attempting to install your rails)
• Pleasefollowtheseinstructionscarefullyasproperinstallationiscriticaltotheperformanceoftherails,theshelf/
racktheysupportandanyfooditemsplacedupontheshelf/rack.
• Properinstallationiscriticaltotheperformanceoftheovenandthesafetyofthe
operatorusingtheoven.
1. Inspecttheovencavitytoensurealignmentpegdimplesare
present(thereshouldbetwodimplesoneachoftheleftandright
cavitywalls)
2. Ensurethecavitywallsanddimplesarecleanandfreeofanyforeign matter,
foodstuffordebris
3. Alignthefirstrail,magnetsfacingoutwards,beneaththealignment
pegdimplesasshowninFig1.1
4. Rotatetherailsupwards,aimingthealignmentpegstowardsthe alignment
pegdimplesasshowninFig1.2
5. Continuetorotate,ensuringthealignmentpegsareinsertedinthe alignment
pegdimplesuntiltherailssnapinplaceasshowninFig1.3
6. Inspecttheinstallationtoensure:
7. Thealignmentpegsareinsertedintothealignmentpegdimples
8. Therailislevelwiththetopandbottomofthecavity
9. Therailissittingflatandflushtothefaceofthesidewallofthecavity
10. Therailisorientedproperly(topoftherailfacingup,bottomoftherail facing
down).(SeeUparrowindicatoronleftsideofeachrail)
11. Followthesameprocedureontheoppositecavitywalltocomplete
installationofthesecondrail.
12. Follow this link to see a video of a rail being installed using this method.
FIG. 1.1
FIG. 1.2
FIG 1.3
DO NOT OPERATE THE OVEN EMPTY - OPERATE WITH FOOD IN THE CAVITY ONLY
DIMPLES

Railproperlyinstalled Railimproperlyinstalled-notindimples Railimproperlyinstalled-upsidedown
andnotindimples
Cleaning the rails
CAUTION: Do not immerse the rails in water, or place them in a dishwasher as this can cause damage to the
magnets and create a potential safety hazard. To clean, follow these instructions only
1. Cleanrailswithacleandampclothorsponge.
2. Removestubborndebrisorfoodparticleswithanon-scratchscrubbingpadorbristlebrush.
3. Drywithatowel.
4. Beforereinstallingtherails,pleasefollowtheinstructionsabovecarefully.
5. Alwaysensurethatthecavitywallsarecleanandfreeofforeignmatter,foodstuordebrisbeforere-installingyour
rails
Storing the rails
Rails can be stored on the outside of the oven, on either side. DO NOT store by placing the face of the magnets
against the side of the oven. Instead, store as illustrated below.
IMPROPERSTORAGE-Donotstorewith
magnetsfacingtheoven
PROPERSTORAGE-Storewithmagnets
facingawayfromtheoven
FIG. 2.1 FIG. 2.2 FIG. 2.3
FIG. 2.4 FIG. 2.5

Condition
Unacceptable
NegativeEffect Acceptable
Inspection1
Nopositioningdepressions
(dimples)oncavitysidewalls
Railswillnotinstallcorrectlyand
canleadtodamagetocavityand
overheatedrails. SeeFig1.1,Page1
Inspection2 Visualsignsofcracksinplastic.
Overallweakeningoftheplastic
materialduetoexposureto
excessiveheat
If cracks appear in your
rails replacement is
required
Inspection3
Anyforeignmagneticdebrison
thesurfaceofthemagnet
Storage1
DONOTstorerailsnearany
smallloosemagneticmaterial
topreventdebrisaccumulation
onmagneticsurface.
Storage2
DONOTstorerailsattachedto
magneticsurfacewithmagnets
facinginward.See Fig 2.4
and 2.5
Magnetsmaybecomedislodged
overprolongedperiodoftime.
Storerailswithmagnetsfacing
outward.SeeFig.2.4and2.5
onpage2.Railmayalsobe
storedinanareaawayfrom
magneticobjects-atleast6"
clearance.
RailHandling
DONOTbend,twistordrop
railsonahardsurface
Magnetsmaybecomelooseand
dislodgeduringoperation
Handlerailwithcare-no
bendingortwisting
Cleaning
DONOTimmerserailsin
water,orcleanwithdegreasers
orsanitizers
Immersionorharshcleaning
agentscanbreakdownadhesive
andcausemagnettodislodge
Removerailsorcleaninplace
withmoistenedclothornylon
bristlebrush
Installation1
AVOIDexcessiveimpact
betweenrailandcavitywall
wheninstalling.
Excessiveimpactcandislodge
magnets
Install per video: Watch Video
Installation2
DONOTinstallrailsunless
ovenhascavitypositioning
depressions(dimples)oneach
side.SeeFig.2.2and2.3for
examplesofincorrectinstall.
Magnetscomeintopointcontact
withcavityandcauselocalized
overheatingundernoload
conditions
SeeFig.2.1forcorrect
Installation
Operation
DONOToperateoven(with
railsinstalled)withoutafood
load.
NoLoadoperationincreases
temperatureofcavitywallsand
maycausebreakdownof
adhesiveanddislodgemagnets OperateONLYwithfoodload
HeatExposure
DONOTexposerailstosudden
temperaturechangeexceeding
212degF,e.g.,droppingrailin
hotwater.
Suddenthermalexpansionwill
weakenadhesivejoint.
Gradualtemperaturechangeis
okay,e.g.,normaloven
operation.
Interfereswithmagnetic
attractiontoovensurface.Can
causeunintentionalarcing
betweenmagnetandcavitywall.
Magnetsurfacefreeofany
foreignmaterial.SEE
STORAGE/HANDLINGguidance.
StandardOperatingProcedure
OnCueShelfSupportRails.
RefertoINSTALLATION, USEandCAREon previous
pages foradditionaldetails