Mercku Tech M2 Bee User manual

MESH Node
Set-up
Guide

Reset
Light
Pins
Thank you for choosing the Mercku M2 Bee mesh node
Set-up in 3 steps
Or visit: www.mercku.tech/help
You need a working M2 router
to use the M2 Bee mesh node.
Need help setting up your M2 router?
Please scan this QR code:

Please download the Mercku app, log into
the app and bind it with the host router.
1. Download the app
Bind

Open the Mercku app and access the “My Wi-Fi” section and
click “+”.
2. Add a Bee node
Mercku
Speed Test Settings
My Wi-Fi

Plug the Bee node into the socket and click the reset button
(red button). When the indicator light turns red and blinks,
click “Add node” on the app to finish the setup process.
3. Plug in the Bee node
Add node
Next
SN: xxxxxxx
Bee node

www.mercku.tech/help
Need help?
If the Bee node fails to connect to the mesh
system or there is no internet, the Bee’s
indicator light will be red and steady. Please
check the setup information on your app’s
interface or the network status of M2 host router.
*
After the mesh system is created successfully,
the Bee node’s indicator light will turn green
and stop blinking.
*
If the Bee node’s indicator light blinks, it means
that the signal is weak. Please move the Bee
node closer to the other nodes (Bees or M2s) in
the mesh network.
*
Too far