ZONE CONTROLLER
251 POWERED
QUICK START
GUIDE
SAFETY WARNINGS
Do not expose the unit to dripping or splashing.
Do not place any object filled with liquid, such as a vase, on the unit.
Do not place naked flame sources, such as lighted candles, on the
unit.
TO AVOID OVERHEATING
Do not position the product in direct sunlight.
Do not position the product near heat sources, such as a radiator.
Leave at least 10cm around the product to ensure sufficient
ventilation.
TO AVOID INTERFERENCE
Do not position the unit near strong electrical or magnetic
radiation, such as near a power amplifier.
RADIO INTERFERENCE
FCC Warning: This equipment generates and can radiate radio
frequency energy and if not installed and used correctly in accordance
with our instructions may cause interference to radio communications
or radio and television reception. It has been type-tested and complies
with the limits set out in Subpart J, Part 15 of FCC rules for a Class B
computing device. These limits are intended to provide reasonable
protection against such interference in home installations.
EEC: This product has been designed and type-tested to comply with
the limits set out in EN55032:2015 and EN55024:2010 + A1:2015.
BUILDING CODE
Due consideration should be given to building and electrical codes
when selecting speaker wiring. In the U.S.A. Class 2 wiring should be
used.
ZONE CONTROLLER
251 POWERED
QUICK START
GUIDE
This product meets or exceeds the Hi-Res audio standards for digital
and analogue processes as defined by the Japan Audio Society.
Manufactured under licence from MQA Limited. The MQA logo is a
trade mark of MQA Limited. © MQA limited 2017.
VISIT US ON THE WEB
www.meridian-audio.com
Copyright © 2017 Meridian Audio Ltd.
Part no: P88458
•
•
•
•
•
•
•
IMPORTANT SAFETY INSTRUCTIONS
Read the instructions.
Keep these instructions.
Follow all instructions.
Do not use this apparatus near water.
Clean only with a dry cloth.
Install only in accordance with the manufacturer’s instructions.
Refer all servicing to approved service personnel.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO
NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE.
This apparatus has been designed with Class 1 construction and
must be connected to a mains socket outlet with a protective earthing
connection (the third grounding pin).
This apparatus does not include a power switch. The apparatus
may be isolated from mains power either by unplugging the power
connector from the rear of the unit, or by unplugging the connector
at the opposing end of the power cord or cable from its supply
outlet. As a result, either or both of these connectors should remain
accessible.
SAFETY WARNINGS
WARNING!
RISK OF ELECTRIC SHOCK – DO NOT OPEN
ATTENTION!
NE PAS OUVRIR – RISQUE DE DÉCHARGE ÉLECTRIQUE
Caution: to reduce the risk of electric shock, do not remove cover.
No user serviceable parts inside. Refer servicing to qualified service
personnel.
The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of uninsulated “dangerous voltage” within the
product’s enclosure than may be of sufficient magnitude to
constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
IP20 EQUIPMENT
CLIMATE
The equipment has been designed for use in moderate climates and
in domestic situations.
Only use at an altitude not exceeding 2000m.
•
•
•
•
•
•
•
