Metaform PICOHYBRID User manual

Part List and Assembly Instructions
Including: Nozzle Changing
Direct Drive Setup
Bowden Setup
Additional Part Fan
USER MANUAL

Tools
- Sizing of parts may vary across illustrations to enhance relevant details.
- Wiring length is not reflective of the actual wire length and is shortened for simplicity.
-Previous assembly steps may not be visible for each stage of setup.
Connected Terminals
Wire Length Shortened
IMPORTANT NOTES
Wire Length Cutoff
Remove the silicone sock from the heat
block.
Step 1
Retract filament from the hotend.
After letting the hotend cool off,
unthread the nozzle using your
fingers.
Pico Hybrid Assembly New Nozzle PTFE Liner 7mm and 11mm Flat Wrenches
(Optional) (Optional)
Step 2

If Nozzle is too tight, use the provided 7mm and 11mm flat wrenches for leverage. With the 11mm
flat wrench, hold the wrench flats on the bottom end of the heater block. Use the 7mm flat wrench
to loosen the nozzle, being careful not to apply any twisting force to the heater block. Carefully
loosen the nozzle until able to remove with your fingers.
Step 3
OPTIONAL
If you need to replace the PTFE liner in a nozzle, proceed to step 4, otherwise skip to step 5.
If nozzle is too tight to remove by hand, proceed to step 3, otherwise skip step 3.
WARNING
Applying twisting forces to the heater block may damage the heatsink of the hotend. Be sure to hold the heater block firmly
when removing nozzles with wrenches to avoid damaging the heatsink. Do not try to remove cold nozzles with filament still in
the hotend.

Remove old PTFE liner from the nozzle by twisting it out to break any hardened filament. Insert new PTFE
liner into the nozzle, making sure the chamfered end of the liner is inserted down into the nozzle. Improper
installation may result in leaks.
Step 6
Reinstall the nozzle using your hand.
Do not use the flat wrenches when
installing the new nozzle.
Step 5
Put the silicone sock back on the heat
block.
Insert Chamfered End
on Tubing First
Step 4
OPTIONAL

WARNING
Wiring reverse polarity can damage Voltage Regulator. Ensure the correct polarity by matching the coloring of wires between
each plug.