Metra Electronics Satellite Radio Installation instructions

1-800-221-0932
INST44-SIXM © COPYRIGHT 2004-2009 METRA ELECTRONICS CORPORATION REV. 07-10-09
www.metraonline.com
SATELLITE RADIO ANTENNA
ADHESIVE/MAGNET MOUNT
The Metra Sirius and XM Satellite Radio Antenna is designed solely for Sirius and XM Digital
Satellite tuners. It is designed to receive both satellite and terrestrial signals to ensure that
you have an uninterrupted signal.
INSTALLATION PREPARATIONS
Before mounting the antenna, first you need to decide where the antenna will be placed.
Some considerations for placement of your Sirius and XM satellite antenna are:
• The roof is the most desired site since it is the highest point on the vehicle. The antenna
should be placed on a minimum of a 12”x12” metal section to ensure the best reception.
Make sure if the vehicle has a roof rack that the antenna is not blocked. This might require
the antenna to be placed off center.
•On convertibles and fabric top vehicles, the trunk lid is an acceptable location.
•It is NOT recommended to mount the antenna inside the vehicle.
Once an acceptable location has been found, plan the routing of the cable from the antenna
to the receiver. Avoid any locations that might kink, crimp, or cut the cable. If drilling through
metal, be sure to use a grommet.
INSTALLATION
•At the location selected for the antenna, clean the area with an alcohol swab to clear away
any dirt or debris that might scratch the vehicles paint under the antenna.
• Adhesive mount:
1. Peel the protective backing off of one side of the two-sided tape and press the tape onto
the bottom of the antenna.
2. Peel the protective backing off of the other side of the tape and then press down the
antenna at the predetermined mounting location for about 60 seconds.
•Magnet mount:
1. Mount the antenna at the predetermined mounting location. (See note on next page)
Continued on next page
•Then route the cable under the window molding to conceal the cable. You can use a small
flathead screwdriver or a dental pick to help with routing of the cable.
•Enter the vehicle at the predetermined location making sure the cable is out of the way of
any moving parts. If possible, wire tie the cable to a harness or another stationary object
to prevent the cable from coming in contact with any moving parts.
•Run cable to satellite receiver. If there is any excess cable, use a wire tie to bundle up the
cable. Do not bend the cable severely as damage may occur to the cable.
•Plug antenna into receiver then test for reception by going to the preview channel.
USE AND CARE
•THE SIRIUS/XM ANTENNA IS MAINTENANCE FREE.
Notes:
Adhesivemount:
1. Allow 20 minutes for the adhesive to set before driving vehicle.
2. Do not go through automatic car washes for at least 72 hours after antenna installation.
Magnet mount:
1. IF you plan on going through automatic car washes, removing the antenna is
recommended since damage could occur to the antenna.
Normal rain will not hurt the antenna.
BACK SIDE
FRONT