23
BATTERY SAFETY INFORMATION
‘Let’s care for the environment!’
The wheelie bin symbol indicates that the product must not be disposed of with other household waste. Please
use designated collection points or recycling facilities when disposing of the item. Do not treat old batteries as
household waste. Take them to a designated recycling facility.
QUICK START IMPORTANT INFORMATION
• Do not play with the unit in the street or where there is vehicular traffic or in heavily traveled areas with pedestrians.
• Do not stand on, sit on or throw the car or remote as doing so can result in injury to the person and irreparable
damage to the unit.
• Avoid running the car into furniture, walls, pets, people etc., as doing so may cause injury to the people and pets
and irreparable damage to the unit.
• Avoid driving the car through water, mud, etc.
• Keep long hair and loose apparel, such as shoestrings, away from the rotating wheels of the unit.
• It is recommended to drive the car on hardwood flooring.
• Keep the remote controls in range to operate the car correctly.
• If the car is not functioning properly (jams or makes noises), turn the remote and car OFF (O), and manually transform the
car to the racer position.Then, turn ON ( I) the remote and car again.
• If car runs slowly, replace the batteries.
• Turn off both the car and remote after use to conserve battery power.
• Wipe the unit clean with a damp cloth. Keep moisture away from the battery compartment.
• Frequency band range is 2.400GHz - 2.480GHz.
• Maximum radio-frequency power is 5dBm.
1
Turn the car ON ( I). Turn the remote control ON ( I).
3
Transform the car from racer to dozer with
the center buttons on the remote control.
Drive the vehicle forward by pressing both
arrow buttons at once. To turn left or right,
press only the left or right arrow button.
• Use only size“AA”(LR6) alkaline batteries (6 required).
• Charging of rechargeable batteries should only be done under adult supervision.
• Remove rechargeable batteries from the product before recharging.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Be sure to insert the batteries correctly and follow the toy and battery manufacturer’s instruction.
• Always remove exhausted or dead batteries from the product.
• Dispose of dead batteries properly: do not burn or bury them.
• Do not attempt to recharge non-rechargeable batteries.
• Avoid short-circuiting battery terminals.
• Remove batteries before placing the unit into storage for a prolonged period of time.
2
For best results use on a hard, at surface in a large open area.
NOTE: To properly pair the car and the remote control turn the car ON ( I ) rst. Then, turn on the remote. The red light
on the remote control will blink red until it is paired. The light remain solid once they are paried and ready to drive.
FCC COMPLIANCE
NOTE:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a
residential installation.This equipment generates,uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference,and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Caution: Modifications not authorized by the manufacturer may void users authority to operate this device.
This device complies with Industry Canada license-exempt RSS-210. Operation is subject to the following two
conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including
interference that may cause undesired operation of the device.
CAN ICES-3 (B)/NMB-3(B).
RACER
RACER
FORWARD
DOZER
DOZER
FORWARD
IO O I
