MGI ZIP series User manual

SEAT, SAND BUCKET LOOP, SAND BOTTLE INSTALLATION
The seat for your MGI Zip Buggy is designed to be installed on the Right hand side of your buggy.
Once installed, your horizontal seat stem should look like the below image.
1. To insert the horizontal seat stem ensure the coloured leaver underneath the chassis is
unlocked as per the below image
2. Insert the seat stem through the chassis so that the end of bracket is positioned
approximately to the centre of the right hand wheel.

3. Push the lever up until it clicks into position
4. You can now fit the seat onto the horizontal seat stem
5. If you also have a sand bucket loop or sand bottle, please see the below images for
installation

6. Fit the sand bucket loop onto the left hand side of the seat stem and fasten the screw until
firm.
7. Fit the sand bottle adaptor onto the left hand side of the seat stem and fasten the screw
until firm
8. Fit sand bottle into the adaptor as per the below image

9. If you are fitting a sand bucket loop only, connect the loop to the bar supplied and fasten the
screw until firm. Release the coloured lever underneath the buggy and insert the bar
through the centre of the chassis
10. Push the lever up until it clicks into position
11. If you are fitting a sand bottle only, release the coloured lever underneath the buggy and
insert the sand bottle adaptor through the centre of the chassis

12. Push the lever up until it clicks into position
13. Insert sand bottle into the sand bottle adaptor