Microdia MMCmicro User manual

MMCmicro
TM
OPERATING MANUAL
SPECIFICATIONS
CONFIRMATION OF PARTS LIST
Dimension: 14 (L) x 12 (W) x 1.1 (T) mm
Weight: Approx. 0.4g
Voltage Performan e: 1.7V to 1.95V or 2.7V to 3.6V
Temperature Performan e:
-40°C to +85°C
Clo k Frequen y: Minimum 2.4MB/se
Humidity Performan e: 5% to 95%RH
MMCmi ro
TM
Card
MMCmi ro
TM
Adapter
Plasti Case Manual
NOTE: Spe ifi ations are subje t to hange without noti e.
REMOVAL THE PLASTIC CASE FROM BLISTER
1. Hold tight the blister.
2. Hold the blister upside down with about an in h of distan e
between the blister and the table.
3. Use your fingers to push the edges of the plasti ase.
4. Then MMCmi ro
TM
ard and adapter with plasti ase will
drop on the table.
Step 1 Step 2 & 3 Step 4
REMOVAL AND STORAGE OF THE MMCmicro
TM
CARD IN PLASTIC CASE
1. Hold the ase with both hands when opening and losing.
2. Unlo k and open the lid of the ase.
3. Store or remove the MMCmi ro
TM
and adapter ard in the tray.
Ensure the MMCmi ro
TM
and adapter are pla ed properly on the
tray before losing the ase.
4. Lo k the plasti ase.
Step 2 Step 3
PRECAUTIONS FOR HANDLING AND STORAGE
• Keep out of the rea h of hildren. Get medi al advi e immediately if swallowed.
• Do not tou h the interfa e pin dire tly by hands, metal or hard obje ts.
• Do not modify or disassemble the MMCmi ro
TM
ard.
• Do not wet, heat/fire, impa t, drop or bend the MMCmi ro
TM
ard.
• Do not use or store in a humid and dusty pla e; in hot pla e su h as inside a hot ar, under a blazing sun, near
fire, a stove, an air- onditioner outlet, et .
• Do not expose to strong magnet fields, ele tri al noise and put near orrosive hemi als/gas. This may ause
damage through melting or the emission of heat/smoke or ause produ t failure.
• Do not pla e in ooking applian es su h as mi rowave ovens or high-pressure ontainers.
• Do not deta h the label on the MMCmi ro
TM
ard and adapter. Do not atta h other sti kers/labels on the
MMCmi ro
TM
ard and adapter.

MICRODIA (USA)
Camden Ave., San Jose, CA 95120, USA
MICRODIA (UK)
Bri khill Drive, Manton Height, Bedford,
MK41 7QH, England
MICRODIA (HONG KONG)
International Sales Offi e
1371, HITEC, Trademart Drive, Kowloon Bay, Hong Kong
Tel: [phone] Fax: [phone]
Website: http://www.mi rodia. om
Email: sales@mi rodia. om
DATA PROTECTION
• MICRODIA MMCmi ro
TM
Memory Card omes pre-formatted. Make sure to ba k up all the data on your
MMCmi ro ard before formatting.
• Do not remove the MMCmi ro
TM
ard and swit h off any equipment using the ard when data is being read,
written and transferred. It an ause data to be destroyed.
• Insert the MMCmi ro
TM
ard firmly in the orre t orientation. The produ t will not operate orre tly if it is
inserted in an in orre t orientation or not inserted all the way.
• Parental Guidan e is needed when a hild uses the MMCmi ro
TM
ard. Tea h the hild how to use and prote t
the produ t and insure that the hild follows your instru tions.