Micron Wings MXA-82 User manual

MXA-82 FrSky 7Ch Bare Board
Top
Bottom
The MXA-82 for FRSky radios combines light-weight
with a full array of 7 channels. The board also has an
incorporated bind button for ease of use.
Solder pads are supplied for the signal wire of each of
the 7 channels. Pos and Neg are common for all servos
so the Positive and Negative of each servo need to be
combined and soldered to the board at the same
locations as where the power is supplied.
www.micronwings.com

Example Wiring Configuration
(for brushless motor setup with 4 channels)
Channel Order
CH1---AIL
CH2---ELE
CH3---THR
CH4---RUD
CH5---AUX1
CH6---AUX2
CH7---AUX3
Ch4 –Rudder
Ch2 –Aileron
Ch3 –Elevator
Ch1 –Throttle
BATTERY
ESC
Servo
Servo
Servo
MOTOR

Binding Process
1. Press the BIND button for 2 seconds on the receiver after the unit has been powered on.
The receiver will enter bind mode (the slow blinking LED turns to a fast blinking LED)
2. Turn your transmitter on and put it into bind mode (refer to your transmitter manual). When binding is successful,
the fast blinking LED on the receiver will turn to a slow blinking LED and then to a solid light as soon as a verified
connection has been formed with the transmitter.
Copyright © MicronWings 2014: All rights reserved.
This manual is for personal use only. No unauthorized copying or digital distributing permitted.