Microzone MC6S User manual

Manual
www.microzone.hk
成品尺寸:210x285mm

Index
02
Introduction
03
Usage precaution
04
Product Specification
05
Transmitter controls
06
Airplane Basic operation
07
Helicopter Basic operation
09

Introduction
Warning About usage and change on this product.
!
03
Thank you for purchasing MC6S from Microzone,please carefully read all this instruction before you
start to use it.Meantime,please keep this instruction carefully for further possible guide in the future.
1.This model is only used for Hobby flight.
2.Any problem caused by changing, replaced spare parts is not Microzone’s responsibility,thank you
for your understand.

Usage precaution
04
Before using this model, please check to make sure all the spare parts for this model are included, all
the power for receiver,servo and transmitter is ready to start well. If no function,please check whether
the batteries are full of power.For rechargeable battery,it should be first charged for first usage or
long time not used. Please make sure the voltage is correct for this radio,if it is supported by li-poly
battery or other device.
If spare parts missing, bad function happening,please contact with the distributor or our company for
detailed support. Please specifically pay attention to following notices for safety usage.
1.Children under 14 must be accompanied and instructed by experienced pilot.
2.Donot fly models at night, raining day or strong wind,etc.
3.Special attention should be paid before you turn on the transmitter,while other
models are flying or running.
4.If there is a special regulation for 2.4Ghz radio system at your flying area,please
abide by all regulations for safely flying with this model.
5.Please check every servo works properly and eliminate any interfering signal before
you fly with it.
6.All the Microzone radios are only compatible with Microzone receivers, couldnot be
compatible with other brands’.

Product Specification MC6S
1
2
3
4
5
6
CH
Ch1
CH2
CH3
CH4
CH5
CH6
Airplane
Aileron
Elevator
Throttle
Rudder
Landing gear
Flap
Helicopter
Gyro
Pitch
Frequency
05
1.Application: Helicopter, airplane, car ,boat
2.Big Dot matrix LCD display, resolution 128*64
3.Frequency: 2401.5MHz～2445.5MHz
4.Power: <100mW
5.Working current: <120mA
6.Type: PCM1024
7.Trim: Digital Trim
8.Comfortable menu design, easier to use and setup
9.New joystick design, adjustable tightness and height
10.Multiple swashplate setup,perfectly support CCPM
11.Digital trim, display both graph and number
12.10 models memory,3 sets programmable mixer
13.More than 4 type flight mode, easier to fly aerobatic function
14.11 sets of curve design ,9 point editing each set
15.Computerized 6ch,monitor each detail
16.Dozens of functions for airplane and helicopter control, make flight easier
17.Low Voltage Notice: Battery < 8.4V, power light 1/500ms
18.Modulation: FHSS
MC6S Digital trim Transmitter function
Application: Airplane ,helicopter,car and boat
Frequency:
Sensitivity: -97dBm
Range on the ground: >700m
Type: PCMS 1024 / 4096
Power: 4.8-6V
Size: 45×24×13mm
Weight: 5.8g
2401.5MHz～2445.5MHz
MC6DR 6CH 2.4Ghz Receiver
Receiver connection
Aileron
Elevator
Throttle
Rudder

Transmitter controls
Switch1Switch 3
Antenna
Switch2Switch 4
Elevator
Rudder
/Aileron/
Throttle
Elevator Trim Throttle
Trim
Rudder Trim Aileron
Trim
MENU Key
LCD Display
+ Key
Power switch
Hook
END Key - Key
06

1.Switch on, press MENU button to main menu, press +/- to choose different title.。
2.Choose MODEL sub-menu with +/- buttons, Press MENU button to enter sub menu, choose any mode with +/-
buttons, press MENU button to confirm it, Press END button to return main menu.
ME NU
EN D/ EX IT
Main menu
Airplane
3.Choose REVERSE sub-menu with +/- buttons, Press MENU button to enter sub menu, choose any channel with +/-
buttons, press MENU button to enter REV/NOR setup of this channel, select REV or NOR with +/- buttons, press END to
return main menu.
4.Choose sub-menu with +/- buttons, Press MENU button to enter sub menu, choose any title with +/-
buttons, press MENU button to confirm chosen title, setup parameters with +/- buttons, press END to return main menu.
DR/EXP
5.Choose sub-menu with +/- buttons, Press MENU button to enter sub menu, choose any title with +/-
buttons, press MENU button to confirm chosen title, setup parameters with +/- buttons, press END to return main menu.
END POINT
07
Display instruction
Menu
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT

6.Choose sub-menu with +/- buttons, Press MENU button to enter sub menu, choose any title
with +/- buttons, press MENU button to confirm chosen title, setup parameters with +/- buttons, press END
to return main menu.
SUB-TRIM
7.Choose sub-menu with +/- buttons, Press MENU button to enter sub menu, choose any title
with +/- buttons, press MENU button to confirm chosen title, setup parameters with +/- buttons, press END
to return main menu.
FLAPERON
8.Choose sub-menu with +/- buttons, Press MENU button to enter sub menu, choose any title
with +/- buttons, press MENU button to confirm chosen title, setup parameters with +/- buttons, press END
to return main menu.
FLAP-TRIM
9.Choose sub-menu with +/- buttons, Press MENU button to enter sub menu, choose any title with
+/- buttons, press MENU button to confirm chosen title, setup parameters with +/- buttons, press END to
return main menu.
V-TAIL
10.Choose sub-menu with +/- buttons, Press MENU button to enter sub menu, choose any title
with +/- buttons, press MENU button to confirm chosen title, setup parameters with +/- buttons, press END
to return main menu.
ELVON
08
Airplane Display instruction
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT

1.Switch on, press MENU button to main menu, press +/- to choose diferent title.
2.Choose MODEL sub-menu with +/- buttons, Press MENU button to enter sub menu, choose any mode
with +/- buttons, press MENU button to confirm it, Press END button to return main menu.
3.Choose REVERSE sub-menu with +/- buttons, Press MENU button to enter sub menu, choose any
channel with +/- buttons, press MENU button to enter REV/NOR setup of this channel, select REV or NOR
with +/- buttons, press END to return main menu.
4.Choose DR/EXP sub-menu with +/- buttons, Press MENU button to enter sub menu, choose any title
with +/- buttons, press MENU button to confirm chosen title, setup parameters with +/- buttons, press END
to return main menu.
5.Choose END POINT sub-menu with +/- buttons, Press MENU button to enter sub menu, choose any title
with +/- buttons, press MENU button to confirm chosen title, setup parameters with +/- buttons, press END
to return main menu.
09
Helicopter Display instruction
ME NU
EN D/ EX IT
Main menu Menu
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT

6.Choose SUB-TRIM sub-menu with +/- buttons, Press MENU button to enter sub menu, choose any title
with +/- buttons, press MENU button to confirm chosen title, setup parameters with +/- buttons, press END
to return main menu.
7.Choose sub-menu with +/- buttons, Press MENU button to enter sub menu, choose
any title with +/- buttons, press MENU button to confirm chosen title, setup parameters with +/- buttons,
press END to return main menu.
8.Choose sub-menu with +/- buttons, Press MENU button to enter sub menu, choose any
title with +/- buttons, press MENU button to confirm chosen title, setup parameters with +/- buttons, press
END to return main menu.
9.Choose sub-menu with +/- buttons, Press MENU button to enter sub menu, choose
any title with +/- buttons, press MENU button to confirm chosen title, setup parameters with +/- buttons,
press END to return main menu.
10.Choose sub-menu with +/- buttons, Press MENU button to enter sub menu, choose
any title with +/- buttons, press MENU button to confirm chosen title, setup parameters with +/- buttons,
press END to return main menu.
10
Helicopter Display instruction
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT
ME NU
EN D/ EX IT