Midea AC100-18B User manual

AIR COOLER
MODEL: AC100-18B
OWNER’S MANUAL
READ AND SAVE THESE INSTRUCTIONS
Attention: Pictures in the IM are for reference only.

SAFETY INSTRUCTION
1
1. If the supply cord is damaged, it must be replaced by manufac-
turer,its service agent or a similarly qualified person in order
to avoid a hazard.
2. This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabili-
ties, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the
appliance by a person responsible for their safety. Children
should be supervised to ensure that they do not play with the
appliance.
3. Unplug the appliance during filling and cleaning.
4. Prior to cleaning or other maintenance, the appliance must be
disconnected from the supply mains.
5. Correct Disposal of this product
This marking indicates that this product should not be
disposed with other household wastes throughout the
EU. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, recy-
cle it responsibly to promote the sustainable reuse of
material resources. To return your used device, please
use the return and collection systems or contact the
retailer where the product was purchased. They can
take this product for environmental safe recycling.
6. CAUTION: In order to avoid a hazard due to inadvertent reset-
ting of the thermal cut-out, this appliance must not be supplied
through an external switching device, such as a timer, or con-
nected to a circuit that is regularly switched on and off by the
utillty .

1
3
2
4
5
6
Front Foot-wheel
Rear Foot-wheel
2
INSTALLATION INSTRUCTIONS
Name of components
INSTRUCTIONS FOR USE
Instructions for operation of body
Foot-Wheel Installation
NO. Description
1
Key
2 Water tank cover
3 Honeycomb Filter
4
Water tank
5 Ice Box
6 Universal Wheel

Using the Ice Box
Water + Ice
Water Level
INSTRUCTIONS FOR USE
Instructions for operation of body
Directions for use
Guidelines for water filling and cleaning of water tanks
Press a key on the unit to activate a corresponding function.
For instance:
Press [OFF] Key to activate or deactivate OFF Function.
Press [LOW], [MED], [HIGH] Keys to adjust fan speed.
Press [OSC.] Key to activate or deactivate Swing Function.
Press [COOLER] Key to activate or deactivate COOLER Function.
Please clean the water on the bottom of the water tank in time
Please unplug the power plug when adding water and cleaning.
Before starting up, make sure the pump module is fixed in place, if the pump
module is placed randomly, it may lead to abnormal product humidification
There are two ways to add water:
1.Drain half water tank (pump module not removed), add water directly
2.After detaching the pump module, pump the water tank to add water or clean it
Considerate Hint:
When humidifying, water level in the Water Tank must remain under MAX indica-
tion; replenish water if level gets lower than MIN indication.
3

Directions for use
Guidelines for water filling and cleaning of water tanks
MAINTENANCE INSTRUCTION
The fan requires little maintenance. Do not try to fix it by yourself. Refer it to
qualified service personnel if service is needed.
1. Before cleaning and assembling, fan must be unplugged.
2. To ensure sufficient air supply, the honeycomb filter and dust filter shall be
cleaned regularly.
3. Please wipe the exterior parts with a soft cloth soaking a mild detergent.
4. Do not use any abrasive detergent or solvents to avoid scratching the surface.
Do not use any of the following as a cleaner: gasoline, thinner.
5. Do not allow water or any other liquid into the motor housing or interior parts.
4

CLEANING
1. Be sure to unplug from the electrical supply source before cleaning.
2. Plastic parts should be cleaned with a soft cloth moisten with mild soap. Thor
oughly remove soap film with dry cloth.
5