
09
• Switch off (0) and unplug before cleaning.
• Wipe the outside of the motor unit with a clean damp cloth.
• Handwash the removable parts.
• If you use a dishwasher, the harsh environment inside the dishwasher will affect the
surface finishes.
• The damage should be cosmetic only, and should not affect the operation of the
appliance.
Care and Maintenance
• You may remove the blade unit for cleaning.
• This is best done with the jug upside down.
• Grip the jug handle with one hand.
• Grip the bottom of the blade unit with the other hand.
• Turn the blade unit clockwise till it comes loose from the jug base.
• Carefully, pull it up and out of the bottom of the jug.
• Wash the seal and blade unit in warm soapy water, rinse, and air dry.
• Take great care with the blades – don’t handle them directly, use a nylon washing-up
brush.
• Replace the seal round the blade unit.
• Turn the blade unit upside down, and replace it in the bottom of the jug base.
• Turn the blade unit anti-clockwise to tighten it.
Blade Unit
• Unplug the appliance.
• Fit the spindle to the top of the motor unit.
• Lower the jug on to the motor unit, then turn the jug clockwise, to lock it in place.
• Choose the attachment you need.
• Recipe only for processor:Add 150g honey+ 10g tomato, after at max speed
setting,operation time: 5S.
Using the Processor
• Use the chopper for pulverizing ingredients.
• Use the mixer to mix ingredients together.
• Use the creamer to thicken cream, to beat eggs, and to cream eggs and sugar
together.
• Fit the attachment over the support, and slide it to the bottom.
• Lower the support into the centre of the jug, over the spindle.
• Put the ingredients into the jug - don’t fill it past the max mark.
• Hold the lid with the tube slightly behind the jug handle, set it on the jug, then turn it
clockwise, to lock the tab into the top of the handle.
• To add ingredients while the motor is running:
a)lift the pushed out of the tube.
b)add the ingredients via the tube.
c)replace the pusher.
• To remove the lid, turn it anti-clockwise to unlock it, then lift it off.
With the Support