Midea 385611 Wiring diagram

385611
INSTALLATION
INSTRUCTIONS
USER GUIDE
Warning notices: Before using this product,
please read this manual carefully and keep
it for future reference. The design and
specifications are subject to change without
prior notice for product improvement.
Consult with your dealer or manufacturer
for details.
MIDEA
2 in 1
Cordless Handstick

Instruction Manual
Assembly and other parts instruction
Accessories list:
Tips:
When cleaning the high places, please assemble the accessories on tube.
Body
Tube
Motorized brush
Mode
button
Power
button
Power
indicator
Max mode
Indicator
Power volume
Indicator
Power volume
Indicator
Crevice
Nozzle
Adaptor
Instruction
Manual

Operation 1:
Battery charging:
Tips:
Battery is not full when leaving factory, please remember to charge
up before first usage.
No. Operation instruction
1 Put the body on horizontal surface.
Connect the adaptor to charging port
on battery pack and plug the adaptor tosocket.
When charing, power indicator will twinkle continuously.
1min after charging up, indicator will shut off。
2 Charging time：4-6h
Discharging time：Max mode 15min
Low mode 40min
充端
口
Charging port

Operation 2:
Cleaning:
Note:
To avoid the air flue being blocked, please clean the big particle
waste.（such as paper, cloth and others）。
No. Operation instruction
1 Knob down ”Power button”to start
2 Knob down “Power button”again to stop
3 When only one power indicator is on and twinkle, please
charge it.
Operation 3
Wall mount assembly and usage:
1. Wall mount assembly
When not using the cleaner, please store the cleaner on mount.
电量指示灯
档位按钮
开关按钮
Power
button
Power
Indicator
Mode
button

2. Choose the mount assembly location
a. Fix the mount
Operation 4
Replace Battery
Tips:
1. Laypeople don’t disassemble battery please.
2. Battery must be replaced and repaired by professional
after-sales service personnel.
螺钉孔
Floor
Screw
Hole

Operation 5
Clean and maintain cleaner
Dust cup disassembly and clean
Tips:
To keep the suction power of cleaner, please clean the dust in it
regularly.
1. Push the locker button, open the bottom cover and release dust
2. Knob down the dust cup release button, take down the cup
尘满位置
按下
按下
Max
Line
Push
Push

3. Take out the cyclone from dust cup
4. Disassemble cyclone and clean, all parts are washable.
5. After airing all parts completely, assemble them according to
disassembly steps.
Operation 6
Clean and maintain motorized brush
Note:
1. To avoid affect the normal operation of brus, when roller brush
and wheels is entangled or dusty, please clean and maintain
them.
2. When disassemble and main brush, please make sure it’s not
working

1. Push button and take off the brush.
2. Open the gland of brush, then take out the roller brush and clean，
After cleaning it completely, assemble them according to
disassembly steps.
Tips:
Don’t suggest to wash the brush.
If the brush was tangled by hair, please scissor or knife to clean.
按下按钮
拆下滚刷压盖
拆卸滚刷
Push
Open the gland
Take out roller brush