MiFleet MF603 User manual
What’s Included:
Installation Guide
Fleetsupport@mieet.us | www.mieet.us | 1.866.643.5338 opt. 2Fleetsupport@mieet.us | www.mieet.us | 1.866.643.5338 opt. 2
Solar Powered Asset Tracker
MF603
+
Bolts Screws Nuts
++
Door Sensor Mounting:
Mount the part with the magnet inside the trailer on the primary
door and the other one with wire on the ceiling of the trailer using
appropriate hardware.
Device Installation:
Included with product:
• 4 Self Drilling Screws
• 4 Bolts
• 4 Nuts
Recommended Tools & Supplies: not included
• Electric Drill
• Digital Multi Meter (DMM)
• Wire Strippers
• Crimping Tool
• 7mm Nut Driver Bit
• ¾” Step Drill Bit
•Drill and drill bit:
o 3/32 or 2mm drill bit for pre-drilling for sheet metal
screws (pre-drilling optional)
o 5/32 or 4mm drill bit when using included bolts
•Weatherproof silicone such as GE Silicone II (clear) or Loctite207
(clear) with at least -40°C to 85”C (-40°F to 185°F) temperature.
• Cable Zip-Ties
• Isopropyl Alcohol
• Clean rag
Device Installation:
Special Note:
The recommended mounting location for the MF603 is high on the nose of
the trailer, away from the corner, and just below the top rail with the GPS
antenna pointing up. Install the device per the instructions included in the
box for the MF603.
1. Power Connection Cable -
Unscrew the protective cover from the din cable connection on the MF603
and connect the Power cable. Make sure to seat the din cable securely in
the MF603 and screw it in completely. Secure the cable with metal cable
clamps.
2. Power Connection -
You will need to connect the MF603 cable to the trailer power through
MF603’s Pink (6-24VDC In) and Black (Ground) wires. Wire the red wire
with the corresponding power joint and black wire with the corresponding
ground joint from the trailer.
Wiring Door Sensor:
The nal step to complete the installation of your MF603 is the
connection of the door sensor wires. It is important that you secure
the wires with cable zip-ties making sure to keep away from any
moving parts. With the wires along with the mounting pad on the
ceiling of the trailer combine Yellow and Black wires and then
connect either one wire (no polarity on 2 wires) to the MF603’s Pink
(RS232 Rx) wire and the other wire to the MF603’s Purple (12 VDC
out) wire through the following steps:
1. Strip 2 wires jacket to 7mm.
2. Insert the whole stripped wire into splice and crimp it with tools.
3. Insert crimped splice inth heat tube .
4. Do the same for the MF603’s pink wire.
5. Move the heat tube to cover the whole splice.
6. Heat tube using a blower or lighter until the tube is shrunk.
7. Repeat steps for combining the other wires and connecting them
to the MF603’s purple wire.
Other MiFleet GPS manuals
