Milesight 1000 Series Operating instructions

Milesight-Troubleshooting
Hardware Reset of NVR

1
The following will introduce how to reset NVR via hardware.
1. Position of Reset Button
Series-1000:
100x/1009-UT: There is a hole on the back, use a pin or something like that to
push the button deeper inside the hole.
1009-UPT/UNT: Slide and open the shell, an orange button on the inside like
the figure shown below.
Update
2019.1.7

2
Series-5000:
50XX: Slide and open the right panel, a black button on the inside like the
figure shown below.
50XX-UH/UT: Slide and open the panel, a black button on the inside like the
figure shown below.

3
5016-UPT: Slide and open the panel, a black button on the inside like the
figure shown below.
Series-7000:
70XX: Slide and open the front panel, a reset button on the left side of the
front panel.
70XX-UH: Slide and open the panel, a black button on the inside like the
figure shown below.

4
7032-UPH: Slide and open the panel, a black button on the inside like the
figure shown below.
Series-8000:
80XX: Open the front panel, a hole on the right side of the front panel like
the figure shown below, use a pin or something like that to push
the button deeper inside the hole.
80XX-UH: Slide and open the panel, a black button on the inside like the
figure shown below.

5
2. Reset Steps
For NVRs whose software version is before 7x.9.0.2-r3, or 61.x.x.xx/ 30.x.x.xx/ 1.x.x.xx/
2.x.x.xx, please refer to the steps below:
Step1: Turn off the power;
Step2: Press the reset button;
Step3: Keep pressing the reset button and power on the NVR at the same time;
Step4: You will hear several short “beep” during this time;
Step5: Reset successfully when the short “beep” become an nonstop “beep”.
For NVRs whose software version is 7x.9.0.2-r3 or above, please refer to the steps
below:
Step1: Turn off the power;
Step2: Press the reset button;
Step3: Keep pressing the reset button and power on the NVR, you will hear a short “beep”
sound at the same time;
Step4: After 5 seconds you will hear a “beep” sound lasting about 3 seconds.
Step5: Reset successfully when the “beep” sound stops.
-END-