Milwaukee L4 FFL User manual

EDITION : A
961001550 018331003
unfold:280mmx203mm;
fold:70mmx26mm(+/-2mm)
CM00166845
ECN-CM019714
01 50gsm recycle paper
018331003(L4 FFL-201 ANZ) manual artworkDescription:
MODEL NO
VENDOR
DIELINE
PART NO
ITEM ID
REV. SIZE
SCALE : 100%
Approved By:
Graphic DesignerApproved By: ElectricalEngineer
Approved By:
Quality Assurance Approved By:
Chief Designer / Eng, Manager
MATERIAL
FINISH
COLOR
ECN#
Vincent Lai
2018.09.13
Black
Total: 1C
Approved By:
Legal Depart

WARNING
REDLITHIUM USB FOLDING FLOOD LIGHT
Cat. no.: L4 FFL
IMPORTANT SAFETY INSTRUCTIONS
1. SAVE THESE INSTRUCTIONS - THIS MANUAL
CONTAINS IMPORTANT SAFETY AND
OPERATING INSTRUCTIONS FOR THE
REDLITHIUM®USB BATTERY CAT. NO. L4 B2
AND USB RECHARGEABLE LIGHT.
2. USE AND CHARGE ONLY REDLITHIUM®USB
BATTERIES IN THIS USB RECHARGEABLE
LIGHT. OTHER TYPES OF BATTERIES MAY
CAUSE PERSONAL INJURY AND DAMAGE.
3. BEFORE USING THE BATTERY AND LIGHT,
READ THIS OPERATOR’S MANUAL AND ALL
LABELS ON THE BATTERY AND LIGHT.
4. USE ONLY WITH LISTED/CERTIFIED ITE
POWER SUPPLY. Others may result in a risk of fire,
electric shock or personal injury.
5. AVOID DANGEROUS ENVIRONMENTS. Do not
charge battery in rain, snow, damp or wet locations.
Do not use battery or charger in the presence of
explosive atmospheres (gaseous fumes, dust or
flammable materials) because sparks may be
generated when inserting or removing battery,
possibly causing fire.
6. CHARGE IN A WELL VENTILATED AREA. Do
not block charger vents. Keep them clear to allow
proper ventilation. Do not allow smoking or open
flames near a charging battery. Vented gases may
explode.
7. MAINTAIN CORD. When unplugging charger,
pull plug rather than cord to reduce the risk of
damage to the electrical plug and cord. Never carry
charger by its cord. Keep cord from heat, oil and
sharp edges. Make sure cord will not be stepped
on, tripped over or subjected to damage or stress.
Do not use charger with damaged cord or plug.
Have a damaged charger replaced immediately.
8. USE ONLY RECOMMENDED ATTACHMENTS.
Use of an attachment not recommended or sold by
the battery charger or battery manufacturer may
result in a risk of fire, electric shock or personal
injury.
9. TO REDUCE THE RISK OF ELECTRIC
SHOCK, always unplug charger before cleaning or
maintenance.
10. DO NOT BURN OR INCINERATE BATTERY
PACKS. Battery may explode, causing personal
injury or damage. Toxic fumes and materials are
created when batteries are burned.
11. DO NOT CRUSH, DROP, OR DAMAGE battery.
Do not use a battery or charger that has received a
sharp blow, been dropped, run over, or damaged in
any way (e.g. pierced with a nail, hit with a hammer,
stepped on).
12. DO NOT DISASSEMBLE. Incorrect reassembly
may result in the risk of electric shock, fire or
exposure to battery chemicals. If it is damaged,
take it to a MILWAUKEE®service facility.
13. BATTERY CHEMICALS CAUSE SERIOUS
BURNS. Never allow contact with skin, eyes, or
mouth. If a damaged battery leaks any fluid, use
rubber or neoprene gloves to dispose of it. If skin is
exposed to battery fluids, wash with soap and
water, and rinse with vinegar. If eyes are exposed
to battery fluids, immediately flush with water for 20
minutes and seek medical attention. Remove and
dispose of contaminated clothing.
14. DO NOT SHORT CIRCUIT. A battery pack will
short circuit if a metal object makes a connection
between the positive and negative contacts on the
battery pack. Do not place a battery pack near
anything that may cause a short circuit, such as
coins, keys or nails in your pocket. Do not allow
fluids to flow into battery pack. Corrosive or
conductive fluids, such as seawater, certain
industrial chemicals, and bleach or bleach
containing products, etc., can cause a short circuit.
A short circuited battery pack may cause fire,
personal injury, and product damage.
15. STORE in a cool, dry place. Do not store
battery where temperatures may exceed 50°C
(120°F) such as in direct sunlight, a vehicle or
metal building during the summer.
16. TO REDUCE THE RISK OF INJURY, CLOSE
SUPERVISION IS NECESSARY when an
appliance is used near children.
17. STORE IDLE LIGHT OUT OF REACH OF
CHILDREN. Warm lights can become hazardous
in the hands of children.
18. KNOW YOUR LIGHT. Read this manual
carefully to learn your light's applications and
limitations as well as potential hazards associated
with this type of light.
19. MAINTAIN LABELS AND NAMEPLATES.
These carry important information. If unreadable or
missing, contact a MILWAUKEE®service facility
for a replacement.
20. NOT FOR FALL PROTECTION. Clip is for
mounting/securing light only; do not use for
climbing or hanging other objects.
READ AND SAVE ALL INSTRUCTIONS FOR
FUTURE REFERENCE.
READ AND UNDERSTAND ALL
INSTRUCTIONS. Failure to follow
all instructions listed below, may result in electric
shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS
ADDITIONAL BATTERY SAFETY RULES
WARNING
1
To reduce the risk of fire, personal
injury, and product damage due to
a short circuit, never immerse your rechargeable
light, battery pack or charger in fluid or allow a fluid
to flow inside them. Corrosive or conductive fluids,
such as seawater, certain industrial chemicals,
and bleach or bleach-containing products, etc.,
can cause a short circuit.

Maintenance and Storage
WARNING
WARNING
Inserting the Battery
1. Twist the cap and remove.
3. Replace the cap and twist to secure.
Charging the Battery
Red Solid: Charging, 0-79% charged
Green Flashing: Charging, 80-99% charged
Green Solid: 100% Charged
Red/Green Flashing: Damaged or Faulty Battery
SYMBOLOGY
Volts
Direct Current
Amps
Do not stare into light.
Read Operator‘s Manual
Properly Recycle Batteries
Regulatory Compliance mark (RCM).
This product meets applicable
regulatory requirements.
SPECIFICATIONS
Cat. No. ..................................................... L4 FFL
USB Input Volts ........................................... 5 V DC
USB Input Amps ................................ 0.1 - 2.1A DC
Output Volts ................................................. 4 V DC
Output Amps............................................. 2.1 A DC
Battery Cat. No............................................. L4 B2
Volts............................................................. 4 V DC
Operating Temperature
Battery and Charger ....................
4°C to 40°C
(40°F to 104°F)
Battery and Tool ...........................
-20°C to 60°C
(-4°F to 140°F)
Power Supply Cat. No. ................... 4931 4605 95A
2
BATTERY
WARNING
To reduce the risk of fire,
personal injury, and product
damage due to a short circuit, never immerse
your light, battery pack or charger in fluid or
allow a fluid to flow inside them. Corrosive or
conductive fluids, such as seawater, certain
industrial chemicals, and bleach or bleach
containing products, etc., can cause a short circuit.
Do not expose your battery or rechargeable light to
water or rain, or allow them to get wet. This could
damage the light and battery. Do not use oil or
solvents to clean or lubricate your battery. The
plastic casing will become brittle and crack, causing
a risk of injury.
Store batteries at room temperature away from
moisture. Do not store in damp locations where
corrosion of terminals may occur. As with other
battery types, permanent capacity loss can result if
the pack is stored for long periods of time at high
temperatures (over 50°C (120° F)). MILWAUKEE®
Li-Ion batteries maintain their charge during storage
longer than other battery types. After about a year
of storage, charge the battery as normal.
To reduce the risk of injury or
explosion, never burn or incinerate
a battery pack even if it is damaged, dead or
completely discharged. When burned, toxic fumes
and materials are created.
Disposing of MILWAUKEE®Li-Ion Battery
MILWAUKEE®Li-Ion batteries are more
environmentally friendly than some other types of
power tool batteries. Always dispose of your
battery according to federal, state and local
regulations. Contact a recycling agency in your
area for recycling locations.
Even discharged batteries contain some energy.
Before disposing, use electrical tape to cover the
terminals to prevent the battery from shorting,
which could cause a fire or explosion.
RBRC Battery Recycling Seals
The RBRC™ Battery Recycling Seals (see
"Symbology") on your batteries indicate that
MILWAUKEE®has arranged for the recycling of
that battery with the Rechargeable Battery
Recycling Corporation (RBRC). At the end of your
battery's useful life, return the battery to a
MILWAUKEE®Branch Office/Service centre or the
participating retailer nearest you.
LIGHT
Use and charge only
REDLITHIUM®USB batteries in
this USB rechargeable light. Other types of
batteries may cause personal injury and
damage.
2. Line up the battery with the compartment and
fully insert the battery.
1. Plug your USB cable into a power source such
as the supplied AC wall adaptor, computer or car
port. Charge rates may vary depending on the
power source’s maximum output.
2. Lift the rubber cover to expose the micro USB
port. Insert the micro USB plug into the micro USB
port.
3. The indicator light will display the charging
status:
If the light indicator flashes red and green, check
that the battery is fully seated into the bay. Remove
the battery and reinsert. If the light continues to
flash red and green, the battery may be extremely
hot or cold, or wet. Allow the battery to cool down,
warm up, or dry out and then reinsert. If the
problem persists, contact a MILWAUKEE®service
facility.
Class III appliance
Rated power................................................... 5.7 W
Ingress Protection............................................ IP54

3
Operation
Red Flashing: 0-3% remaining
Red Solid: 3-10% remaining
Yellow Solid: 11-49% remaining
Green Solid: 50-100% remaining
WARNING
Maintenance and Storage
Cleaning
WARNING
To reduce the risk of injury, do not
look directly into the light when
the light is on.
Press the power button to cycle through High,
Medium, Low, and Off. The indicator light will
display the battery life:
To reduce the risk of injury,
always unplug the charger and
remove the battery from the charger before
performing any maintenance. The charger and
battery have no internal serviceable parts.
Never disassemble the battery or charger.
Store your charger in a cool, dry place.
As a general practice, it is best to unplug battery
chargers and remove batteries when not in use. No
battery damage will occur, however, if the charger
and battery are left plugged in.
WARNING
To reduce the risk of injury and
damage, never immerse your
battery or charger in liquid or allow a liquid to
flow inside them.
Clean out dust and debris from charger vents and
electrical contacts by blowing with compressed air.
Use only mild soap and a damp cloth to clean the
battery and charger, keeping away from all
electrical contacts. Certain cleaning agents and
solvents are harmful to plastics and other insulated
parts. Some of these include gasoline, turpentine,
lacquer thinner, paint thinner, chlorinated cleaning
solvents, ammonia and household detergents
containing ammonia. Never use flammable or
combustible solvents around batteries, charger, or
tools.
The light source contained in this
luminaire shall only be replaced
WARNING
by the manufacturer or his service agent or a
similar qualified person.

For a list of MILWAUKEE®dealers, guarantee or service agents please contact MILWAUKEE®
Customer Service or visit our website.
(Australia Toll Free Telephone Number 1300 645 928)
(New Zealand Toll Free Telephone Number 0800 279 624)
or visit www.milwaukeetools.com.au / www.milwaukeetools.co.nz.
Milwaukee Electric Tool Corporation
13135 West Lisbon Road, Brookfield, Wisconsin U.S.A. 53005
Milwaukee Tool (Australia)
21 Kelletts Road, Rowville, VIC 3178
Melbourne, Australia
Milwaukee Tool (New Zealand)
2 Landing Drive, Mangere
Auckland, 2022, New Zealand
Designed by Milwaukee Electric Tool Corp.
Professionally Made in China for Milwaukee Tool (Australia) / Milwaukee Tool (New Zealand)
Printed in China
WARRANTY - AUSTRALIA and NEW ZEALAND
SERVICE - AUSTRALIA and NEW ZEALAND
MILWAUKEE®prides itself in producing a premium quality product that is Nothing But Heavy Duty®.
Your satisfaction with our products is very important to us! If you encounter any problems with the
operation of this tool, please contact your authorised MILWAUKEE®dealer.
Please refer to Australian and New Zealand warranty supplied with tool. This warranty applies only to
product sold in Australia and New Zealand.
961001550-01(A)