MIMAKI JV400-LX User manual

Make sure to wear the attached
goggles and glove when you work.
© 2014 MIMAKI ENGINEERING CO., LTD. M015465-00(D202722-10)-18042014
D202722-10
JV400-LX Daily Care
With a view to using this machine in a better condition, please be sure to the following daily care after at the end of the
daily work. Please refer to “Daily care manual” for the detail.
Cleaning of around the heads
Cleaning of the station
1. Perform [HEAD MAINT.], move the carriage to the
maintenance position and open the left maintenance cover.
(1) Press the key in LOCAL.
(2) Press the key.
(3) Press to select [HEAD MAINT.].
(4) Press the key.
(5) Open the left maintenance cover.
2. Wipe off the ink of around the head and groove with clean stick or waste cloth dipped in
maintenance washing liquid LX.
3. Close the left maintenance cover.
4. Press , complete the cleaning.
1.
Perform [STATION MAINT.], move the carriage to the
maintenance position and open the right maintenance cover.
(1) Press the key in LOCAL.
(2) Press the key.
(3) Press to select [STATION MAINT.].
(4) Press the key.
(5) Open the right maintenance cover.
Left maintenance
cover
MAINT.
[Before cleaning] [After cleaning]
The nozzle part (Never
touch it.)
Clean with a clean stick.
Clean with a clean stick.
• When you clean, fully be careful not to touch the nozzle surface.
Right maintenance
cover
MAINT.
IT

Cleaning of the cap
Wipe off the ink of the cap rubber and cap cover with clean stick or waste cloth dipped in maintenance washing
liquid LX.
Cleaning of the wiper
Put the wiper that you used for one day into a provided case or solvent-resistance-covered-container (glass,
earthenware, etc.) and pour maintenance washing liquid LX.
Take out the wiper and remove ink blot etc. with a Kimwipe®.
Cleaning of around the wiper
Wipe off around the wiper with clean stick dipped in maintenance washing liquid LX.
2. Close the right maintenance cover.
3. Press , complete the cleaning.
[Before cleaning] [After cleaning]
Cap rubber
• Do not clean the mesh inside
the cap at this point.
Execute “DISWAY WASH”
regularly (about once a
week) to clean the mesh
inside the cap.
(Refer to
"Operation Manual" chapter4)
Cap cover
At the start of immersion
At the end of immersion
• Time to immerse the wiper shall be for 1 to 24
hours.
• Wipe off well so that any lint etc. do not
remain on the top edge of the wiper film.
Wiper
[Before cleaning]
[After cleaning ]
[Before cleaning]
[After cleaning ]
Edges of the wiper slider
Wiper guide upper portions
Wiper guide portions one level below