
!
CHARGING AND MAINTENANCE OF THE BATTERY
There are 4 lights on the side of the battery indicating the level of charge.
The battery’s level of charge is also indicated on the Control Panel.
THE BATTERY MUST BE CHARGED AT LEAST EVERY TWO MONTHS.
IT IS ESSENTIAL TO NEVER LEAVE THE BATTERY CONNECTED TO THE CHARGER
FOR MORE THAN 24 HOURS.
SHOULD THESE INSTRUCTIONS NOT BE FOLLOWED, THERE IS A RISK OF BATTERY
MALFUNCTION AND THIS WILL NOT BE COVERED BY THE LIMITED WARRANTY.
HOW OFTEN SHOULD THE BATTERY BE CHARGED?
It is recommended to charge the battery as needed. For instance, if you only use your E-Bike
during brief periods of time and for short rides, the battery may be recharged following several
such rides. If, on the other hand, you are planning a long ride of 40 km / 25 miles or more, it is
recommended to fully charge your battery before leaving. Generally speaking, if the battery
charge indicator on the handlebar or on the battery indicates there is less than a 50% charge
remaining, charging the battery is recommended. Otherwise, the lifetime of your battery will be
reduced.
During the long periods when you will not be using your E-Bike, after charging it
completely for 8 hours, store the battery in a warm environment; 5 to 25 degrees Celsius (if
necessary, see below for removing the battery from the bicycle). Afterward, you must
charge your battery one hour each month, or for two hours every two months.
Otherwise, the lifetime of your battery will be reduced.
To remove the battery from the E-Bike, unlock the battery by inserting the key into battery lock
on lower left side of battery support rack. Pull the battery out of the rear rack. Re-insert the
battery the same way. Be absolutely sure to re-lock the battery in place by closing the key
lock and removing key, before riding the E-Bike.
IMPORTANT: NEVER LEAVE THE BATTERY CONNECTED TO THE CHARGER
AND TO AN ELECTRICAL POWER OUTLET FOR MORE THAN 24 HOURS
(DURING THE WHOLE WINTER FOR INSTANCE). THIS WILL DAMAGE YOUR
BATTERY AND YOUR CHARGER. THIS MUST ABSOLUTELY BE AVOIDED.
While charging the battery please follow the following steps in order:
1) Connect the charger cable output plug into battery input socket.
2) Connect the charger cable input plug into city electrical output socket.
3) When the green light is lighted, the battery is fully charged.
4) Disconnect the plug from the city electrical output socket and then disconnect the charger
cable from the battery. Replace the rubber dust protector on the battery so it fits snuggly in
place.
Use only the original battery and charger supplied with your MINELLI E-Bike.
Never expose the battery or the charger to heat.
Never dismantle or modify the battery or the charger.