Mini Gadgets BBSAirFreshener User manual

1 Version 1.5
Bush Baby Stealth Air
Freshener Manual
SKU: BBSAirFreshener

2 Version 1.5
THANK YOU FOR PURCHASING THE
BBSAIRFRESHENER
Please read this manual before operating the
camera and keep it handy.
Your purchase should include:
•1 x BBSAirFreshener
•1 x 16GB MicroSD Card
•1 x MicroSD Card Reader
•1 x User Manual
•1 x Remote
•1 x MiniUSB 8Pin Cable
•1 x AC Adapter
•1 x Tweezers

3 Version 1.5
GET FAMILIAR WITH YOUR AIR FRESHENER CAMERA

4 Version 1.5

5 Version 1.5

6 Version 1.5
BEFORE YOU START
Note: If you are not located in the US, or if you intend
to use this product anywhere other than the US, you
will need to purchase a converter in order to use the AC
wall plug in and avoid damaging the product. Because
different countries use different voltages in their
electrical wiring, you will need a converter that adapts
to the current in your particular country.
IMPORTANT WARRANY INFORMATION: If the
warranty sticker on your device has been removed or
tampered with, your lifetime warranty will be voided.
You may be charged fees or denied a return should this
happen.
Please note that this is not a functioning air freshener.
OPERATING THE BUSHBABY CAMERA
IMPORTANT NOTICE: Allow the device to charge 8-10
hours before using.

7 Version 1.5
CHARGING THE BATTERY
1. Connect the battery to the camera (figure C on
page 4)
2. Plug the provided mini-USB cable into the mini-
usb 8 pin port on the camera board.
3. Plug the other end of the USB cable into the
wall AC adapter and plug it into the wall.
4. Wait 8-10 hours for a full charge.
HOW TO TURN ON THE BUSHBABY CAMERA
1. Press the Power Button on the remote control
one time (see page 5).
2. The device is now in Standby mode.
HOW TO RECORD CONTINUOUS VIDEO (720P)
1. When the camera is in Standby Mode, press the
“B” button once quickly (see page 5). The unit
will vibrate twice.
2. Once the device stops vibrating, it starts
recording video.
3. To stop the recording, press the B button again,
and wait three seconds.

8 Version 1.5
HOW TO RECORD CONTINUOUS VIDEO (1080P)
1. While the camera is in standby mode, hold the
“C” button for 3 seconds then let go.
2. The unit will vibrate three times. The camera is
now recording 1080p video.
3. To save video and return to standby mode,
quickly press the C button, and wait three
seconds.
HOW TO RECORD MOTION DETECTION
1. In Standby mode, press the “D” button one
time (see page 4). The device will vibrate three
times.
2. The unit is now in motion detection mode and
will begin recording video once motion is
detected. NOTE: there will be no indication
when the device detects motion –it will simply
start recording.
3. To return to standby mode and stop motion
detection, press the “D” button again. The unit
will vibrate.

9 Version 1.5
HOW TO TAKE PICTURES
1. When the camera is in Standby Mode, press the
“C” button (see page 4). The unit will vibrate,
and then take a picture. It then returns to
standby mode.
MICROSD CARD SLOT (FIGURE B)
1. To access the MicroSD Card Slot, you must twist
off the bottom of the air freshener.
2. To remove the SD card, use the included
tweezers to push on the card so it ejects. The
MicroSD card is spring loaded.
3. To reinsert the SD card, use the tweezers to
carefully insert the card until it clicks into place.

10 Version 1.5
MicroSD cards 64GB and above will require special
formatting to work. The device will not function with
these cards if they are not properly formatted
beforehand.
Visit www.mgidownloads.com/Software and download
the “guiformat.zip” file. Extract the files and follow the
instructions in the “64GB SD Card Formatting.pdf”
document.
IMPORTANT NOTICE: Ensure that the device is off
before inserting the MicroSD card. Otherwise potential
corruption of the card file(s) may occur.
RETRIEVE THE FILES TO YOUR PC
1. Connect the MicroSD card to your computer
using the MicroSD card reader.
2. Locate “Removable Disk” inside the (My)
Computer folder.
•AutoPlay Removable Disk > Open folder
to view files