Page 3
ERASER M35080 manual
ERASING INSTRUCTIONS
To erase the 35080/160 Eeprom, it must follow the procedure below:
1. Connect the clip to the eraser;
2. Switch on the eraser connecting it to its power supply;
3. The red LED must be always on;
4. Clip the Eeprom; the red LED will start to ash. When the Eeprom will become empty, the red
LED will switch o, while the green one will be on.
If after twenty seconds the red LED is still ashing, it could be caused by one of these problems:
1. The Eeprom is not connected as well: try to clip it again;
2. The Eeprom is dirty: it has to be cleaned with some solvent;
3. The Eeprom is damaged: it has to be replaced;
4. The Eeprom is defective;
5. The Eeprom has been clipped on the wrong side: turn it and clip it in the correct way.
>
When an Eeprom is erased, it’s possible to erase a
new one without switching o the eraser; all you
have to do is clip the new Eeprom. The eraser will
automatically detect it.
The Eeprom is suddenly erased af-
ter being clipped, without asking
any authorization.
To previously save the content
you should do it before clipping it,
using a Eeprom programmer for
35080/160, such as our
EECLIP with SEP-EE35 clip.
WARNING
