MINOURA P-60 CLOSET-CYCLIST User manual

!
!
2
3
CC-100 “CLOSET-CYCLIST” instruction manual
Please read this instuctions carefully before use.
Thank you for purchasing Minoura CC-100 “Closet-Cyclist” bike
display stand.
This stand can hang off up to two bikes vertically in a narrow space,
so you can place this stand even in a closet in your room.
This stand is designed for standard two wheel
bicycles. Do not use this stand for electric bikes
or tandems. The weight limit for two bikes is 50
kgs. or 110 lbs.
Make sure the stand is used on a level floor.
Failing to set up and use this stand on a level
floor may cause the stand to fall over and cause
damage or injury.
This stand requires some assembly. You will need a M4 Hex wrench
and a 13 mm spanner in order to assemble Closet-Cyclist completely.
IMPORTANT NOTES
HOW TO ASSEMBLE YOUR CLOSET-CYCLIST
1Screw the foot adjuster to the nut located on
each leg end.
Insert four M8x55 bolts into the holes on the
bottom of the Lower Pillar, then put through
the legs. The long leg is for rear section, and
the short legs are for front section. Be sure to
fit the legs to the shape of the horrow of the
bottom plate. Lower Pillar
Rear Leg Bottom Plate
Front Leg
(Fig. A)
(Fig. B) (Fig.C)
Install the ReinforcementArms between the Lower
Pillar and the Front Legs by tightening the M6x14
bolts for the pillar side, and M6x30 bolts for the
leg side. After installing the ReinforcementArms,
tighten the M8x55 bolts firmly. Wrong
step may make you unable to install
the Reinforcement Arms.
Reinforcement Arm

4Place the Connecting Plates at the top of the
Lower Pillar. Connect the Upper Pillar to the
lower pillar then tighten the M6x14 bolts
firmly. Now the base frame is completed.
Upper Pillar
Connecting
Plate
Lower Pillar
5Next, you'll install the Front Wheel Hook and
the Rear Wheel Support Arm to the pillar.
Disassemble the band clip (see Fig. E).
Wrap the stainless band around the pillar, in-
sert the end of the band between another end
and the square nut.
Put the plastic bracket onto the band, attach
the hook or support arm, then tighten the bolt.
(Fig. D)
(Fig. E)
Front Wheel Hook
Rear Wheel Support Arm
Stainless Band
Plastic Bracket
6Install the Front Wheel Hook at the best height
for your bike on the Upper Pillar.
Install the Rear Wheel Support Arm on the
Lower Pillar. Make sure the bike is held se-
curely.
(Fig. F)
Completed Closet-Cyclist
FOR MORE INFORMATION
For parts or service outside of Japan or North
America, please consult your local shop or refer our
international distributor list (found on our web site)
for the distributor in your country.
MINOURA APAN
1197 1 Godo, Anpachi, Gifu 503 2305 Japan
Phone [phone]
Fax [phone]
Email : [email protected]
http://www.minoura.jp
MINOURA NORTH AMERICA
(for North American residents only)
1996 East Avenue, Hayward
CA 94541 5454 U.S.A.
Fax [phone]
Email : [e-mail]
MADE IN JAPAN
Copyright 2002 Minoura Co.,Ltd. All rights reserved