MINOURA VERGO User manual

VERGO instruction manual
Thank you for purchasing the “VERGO” bike mount kit.
You can hold two or three bikes in the cargo space of your vehicle or on the truck bed easily and
with stability.
Please read the following instructions carefully before use.
HOW TO USE VERGO
<Mounting Example>
Two bikes in a mini-van
1. Place VERGO on aflat floor of the cargo space.
VERGO itself is free standing so uneven
floor design will compromise stability.
2. Remove the front wheel, then clamp the front
fork on the Fork Mount with the supplied
quick release skewer.
When you need to adjust the bikesposition, just
slide the Fork Mount by loosening the knob
bolt and moving the mount in either direction.
Slide to the desired position,then tighten the knob
bolt firmly to fix the position.
Make sure both adjustment position guides are
properly in the rail of the main frame.
3.
4. The Fork Mount can be twisted in 25 degrees in
both directions. This makes for easy adjustment
for handlebar issues and savesspace.
Understand: Bikes on VERGO are not attached to. If you drive hard, the bikes may move around
in your vehicle. To keep the bikes stable, we recommend tying bikes down with a long strap.
Twisted Fork Mount position
CAUTION

VERGO is already assembled so you don’t need
to disassemble the kit.You may want to add
or replaceoptional Fork Mounts. To do so,
follow the steps.
Knob Bolt Fork Mount
Guide Plate
Base Frame
Base Plate
End Cover
Screw & Washer
Rail
1. Remove the two screws under the End
Cover with a phillips screwdriver, then the
End Cover will be removed.
2. Disassemble the Fork Mount. It’s simple,
just remove the knob bolt.
Insert the Base Plate into the Base Frame.
Be sure the direction of the Base Plate must be “M” style, not “W” style.
Place the Guide Plate onto the Base Frame and confirm both adjustment position guides
on the back side are properly fitted to the Rail. The guide will be flush with the base frame.
Place the Fork Mount on the Guide Plate then tighten the Knob Bolt.
3.
4.
5.
6. Finally, insert the End Cover to the Base Frame and tighten the screws.
OPTION
The “DH Fork Mount” for 20mm axle is available as an option.
DH Fork Mount
for 20mm axle
More Information
Contact: MINOURA JAPAN HEAD OFFICE
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Phone [phone] / Fax [phone]
Email : [email protected] / http://www.minoura.jp
MINOURA NORTH AMERICAN CENTER
1996 East Avenue, Hayward, CA 94541-5454 U.S.A.
Phone [phone] / Fax [phone]
Email : [email protected]
MADE IN JAPAN
How To Disassemble and Assemble