Mircom TX3-BBCX-4W Reference guide

TX3-BBCX-4W Wiring
                
                
           
                          
!  "   #         
        
MOUNT THE CARD ACCESS CONTROLLERS
1. Mount up to 4 card access controllers in the enclosure. Mount each card so that
the P7 LED display port is on the left.
2. Mount the cards in two layers using the standos.
3. Connect the LED ribbon cables to the P7 LED display ports on the card access
controllers.
Figure 1. Mounting the card access controllers
© Mircom 2014
Printed in Canada
Subject to change without prior notice
LT-1182 rev 0
A complete library of product
information is available at:
www.TX3.mircom.com

WIRE THE CARD ACCESS CONTROLLERS
There are two battery shelves.
1. Connect the two upper cards to the batteries on the top shelf with the longer
cables.
2. Connect the two lower cables to the batteries on the lower shelf with the
shorter cables.
3. Connect the battery cables to the BAT + (red) and BAT - (black) terminals on the
card access controllers.
Longer cables to
upper battery shelf
Shorter cables to
lower battery shelf
Figure 2. Wiring the card access controllers to the batteries
© Mircom 2014
Printed in Canada
Subject to change without prior notice
LT-1182 rev 0
A complete library of product
information is available at:
www.TX3.mircom.com
Upper cards
Lower cards