Mistral 6200-0 Parts list manual

Ceiling Exhaust Fan
6200-0
6250-0
Installation Instructions / Warranty Card
Important:
Please retain this warranty

245mm
6200-0
Installation Instructions
6200-0 & 6250-0
All fans should be installed by a suitably qualified person in accordance with AS/NZ3000.2000
and relevant building codes. Disconnect supply before making any electrical connections.
For best results provision should be made for return air to enter the room on the opposite
side. In some instances a return air grille/vent may be required.
Installation:
1. This card can be used as a template for making appropriate fan mounting hole size.
2. Cut hole of the required diameter in the desired position in the ceiling.
3. Attach earthed plug base on joist as near as possible to mounting hole.
4. Remove grille by pulling from outside edge.
5. Support fan whilst connecting 3-pin plug to plug base.
6. Insert fan into opening in the ceiling. Push the 3 brackets back through the duct (see diagram). Pull
screws down and tighten until duct is firmly fixed to the ceiling.
Caution:
1. Fan must be mounted at least 120cm above any hotplate and have at least 50cm of clear space
above the fan blades.
2. Do not install in canopies.
3. If ducting is required, its diameter over the full length shall be no smaller than the diameter of the fan
blades and no longer than 1 metre. Restrictions of any kind will affect performance of the fan.
WARNING:
The appliance is not intended for use by children or infirm persons without supervision. Children
should be supervised to ensure they do not play with the appliance.
Cleaning (Ensure fan is unplugged or switched off at mains):
1. Remove grille by pulling outside edge of grille down.
2. Wash grille in hot soapy water and wipe fan blade.
3. Replace grille by pushing grille into fan opening. Fan blade may be removed by undoing screw in the
centre of the fan blade.
295mm
Use this template to mark mounting hole for the fan. Use a nail or similar object
to anchor the template at the centre hole, then insert a pencil through the
template at the 245mm or 295mm marking and scribe a circle.
Centre Hole
TEMPLATE 6250-0
Ceiling
PUSH
PUSH
PUSH
PULL SCREW DOWN
TIGHTEN

Products of Gerard Industries Pty Ltd ABN27007873 529
12 Park Terrace, Bowden, SouthAustralia 5007
Telephone [phone] Facsimile [phone]
Internet clipsal.com
E-Mail[email protected]
F1724
Replacement Warranty
The benefits conferred by this warranty are in addition to all other rights and remedies in respect of the
product which the consumer has under the Trade Practices Act and similar State and Territory laws.
The original purchaser of this Mistral Exhaust Fan is provided with the following warranty, subject to the
following conditions. Gerard Industries Pty Ltd warrant this product for a period of 3 years from the
date of purchase for all parts defective in workmanship or materials. All defective parts will be
replaced free of charge. The following exclusions do not preclude the purchaser from those statutory
rights consumers have under the Trade Practices Act or similar State and Territory laws.
Replacement Warranty Conditions
1. This warranty is only valid for appliances installed according to the manufacturer’s instructions.
2. This appliance must not be modified or changed in any way.
3. All wiring must be carried out by a licensed electrician or similarly qualified person and must be
connected to the voltage requirements as specified on the ratings label.
4. The manufacturer does not accept liability for any direct or consequential damage, loss or other
expense arising from misuse or incorrect installation and operation of the appliance.
5. Warranty will only be given on appliances where proof of purchase date is provided, e.g. original
invoice or copy.
6. As a record of your purchase, please fill out the following details and file this information with your
purchase invoice.
Mistral Model Number
Serial Number
Purchased From
Date of Purchase
© Copyright 2002
WA
Perth [phone]
TAS
Hobart [phone]
Launceston [phone]
NT
Darwin [phone]
NZ
Nth Island [phone]
Sth Island [phone]
For Warranty Service please call your nearest Clipsal Office.
NSW
Sydney [phone]
Albury [phone]
VIC
Melbourne [phone]
Country Areas 1800 653 893
QLD
Brisbane [phone]
Townsville [phone]
SA
Adelaide [phone]