Mistral MSP610 User manual

Model: MSP610
Instruction Manual
Stainless Steel
Sandwich Press

2
Important Safeguards
When using electrical appliances,
in order to reduce the risk of re,
electric shock, and/or injury to
persons, basic safety precautions
should always be followed, including:
For Your Safety
Read all instructions carefully, even if you are
quite familiar with the appliance.
• To protect against the risk of electric shock
DO NOT IMMERSE any part of this appliance
in water or any other liquid.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory and mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
• Children should be supervised to ensure that
they do not play with the appliance.
• Switch off and remove the plug from the
power outlet before cleaning or when not in
use.
• To unplug grasp the plug and pull from the
power outlet. Never pull power cord. Never
carry the appliance by the power cord.
• Do not operate the appliance with a
damaged power cord or plug or after the
appliance malfunctions, has been dropped
or damaged in any manner.
• Do not let the power cord hang over the
edge of a table or counter, or touch hot
surfaces. Do not place any part of this
appliance on or near a hot gas or electric
burner or in a heated oven.
• Do not use this appliance for anything other
than its intended use. This product is intended
for household use only.
• Do not attempt to repair or disassemble the
appliance. There are no user-serviceable
parts.
• Do not use outdoors.
• The use of attachments or accessories not
recommended or sold by this appliance
manufacturer may result in re, electric shock
or personal injury.
• Avoid touching hot surfaces during use as
they may become hot and could cause
burns. Allow to cool before cleaning.
• The appliance should always be operated on
a level, heat resistant surface. Operating the
appliance on sinks, drain boards, uneven or
inclined surfaces should be avoided.
• Never use harsh, abrasive or caustic cleaners
or oven cleaners to clean this appliance.
• The appliance is not intended to be operated
by means of an external timer or separate
re-mote control system.
FAILURE TO OBSERVE THESE CAUTIONS MAY
RESULT IN DAMAGE TO THE APPLIANCE.
CAUTION: HOT SURFACES.
The surfaces are liable to get hot during
use, do not touch.
Warning
If the supply power cord is damaged, the power
cord must be replaced by the manufacturer,
its service agent or similarly qualied persons in
order to avoid a hazard.
This product has not been designed for any uses
other than those specied in this booklet.
Save These Instructions

3
Features of Your Stainless Steel Sandwich Press
Adjustable Height
Dial - Turn the dial
to lock top plate
at various heights
- ideal for open
cheese melts
Non Stick
Grill Plate
Cool Touch Handle
Green - Ready Light
(Indicates that it is ready to use)
Red - Warm Up Light
(Indicates when unit
is switched on and
heating up)
Drip tray
Locking
Latch

4
Getting To Know Your
Stainless Steel Sandwich
Press
Congratulations on the purchase of your new In
My Kitchen Stainless Steel Sandwich Press.
Before rst using your new In My Kitchen
Stainless Steel Sandwich Press, it is important
that you read and follow the instructions in this
handbook, even if you feel you are familiar with
this type of appliance.
Your attention is drawn particularly to the section
dealing with IMPORTANT SAFEGUARDS.
Find a safe and convenient place to keep this
handbook for future reference.
This appliance has been designed to operate
from a standard domestic power outlet. It is not
intended for industrial or commercial use.
How to Use Your
Stainless Steel Sandwich
Press
Note: When using the Stainless Steel
Sandwich Press for the rst time, the unit
will emit a ne smoke. This is caused by
the heating of the elements and new
components and can be disregarded.
Before rst use, carefully unpack the Stainless
Steel Sandwich Press and remove all packaging
material. Wipe the body of the Stainless Steel
Sandwich Press with a soft dry or damp sponge
or cloth.
Place the Stainless Steel Sandwich Press on a at
level surface and slide the storage locking latch
on the right side of unit away from you. (It will
unlock the cooking plates).
Cooking plates must be in the closed position for
pre-heating.
Before using your Stainless Steel Sandwich Press
for the rst time, the non-stick plates must be
seasoned during the preheating time (until the
green light comes on) to protect the non-stick
surface. When the Stainless Steel Sandwich Press
is hot it is recommended that you season the
non-stick surface by rubbing 1 tablespoon of oil
over the Stainless Steel Sandwich Press plates.
Use a thick amount of paper towels and take
care – remember the Stainless Steel Sandwich
Press is hot.
1. Plug the power cord into a standard
domestic power outlet and switch the power
outlet ON. The Power light (Red) light will
illuminate and stay on.
2. Preheat the plates for 5-8 minutes (or until
the green light illuminates). Season the
plates accordingly if using the Stainless Steel
Sandwich Press for the rst time.
3. During the preheating time prepare your
sandwich and when ready, open the Stainless
Steel Sandwich Press and place the sandwich
on the Bottom Cooking Plate. Always place
Sandwiches towards the rear of the cooking
plate. Close the Top Cooking Plate and it will
automatically adjust to the thickness of the
sandwich because of the adjustable plate
height. This will ensure an even toasting.

5
4. Toasting should take approximately 5-8
minutes. However, exact toasting times will
depend on types and thickness of breads
and different llings used.
5. Open the lid when the sandwich is cooked.
Always remove the sandwich by using plastic
or wooden spatula. Never use metal utensils
as this may damage the Non-Stick Coating.
6. Close the lid to preserve the heat until ready
to toast the next sandwiches.
7. After use, remove the plug from the wall
socket.
Note: The green light will go on and
off throughout the cooking process
indicating that the correct temperature
is being maintained.
Open Cheese Melts
Pre-heat the Stainless Steel Sandwich Press until
the Green Ready Light illuminates (Cooking
plates must be in a closed position).
Place the Sandwich to be melted on the bottom
plate. Adjust the adjustable height dial so that
the top plate sits just above the open sandwich
surface. Close the unit.
The Top Plate will radiate the desired heat to
melt the ingredients.
Toasting “Melts” should take approximately 3-4
minutes. The toasting time will vary depending on
the ingredients being used, the height of the top
plate and personal preference.
For Better Results
Breads with a high-sugar content (e.g. fruit
loaf, raisin bread or brioche) will toast more
quickly than sandwich breads. White, brown or
wholemeal bread can be used.
For sweet snacks, sprinkle caster sugar over the
buttered sides of the bread.
For a wholesome meal, Panini bread can be
toasted quickly and easily with any number of
nutritious llings and served with a side salad.
Be careful when biting into a freshly toasted
sandwich. Fillings such as cheese, tomato and
jam retain heat and can burn if eaten too
quickly.
Suggested Breads
Turkish bread
Foccacia
Olive bread
Sour dough
Baguettes
Bagels
English mufns
Crusty Italian-style bread
Lavash bread, mountain bread, pita bread or
tortillas may be rolled around most llings.
Try raisin bread or brioche with sweet llings.

6
Suggested Fillings
• Cut surfaces of bread and rub with a sliced
garlic clove, top with thinly sliced spicy char
grilled lamb, nely sliced red onion, hummus
and fruit chutney.
• Spread bread with prepared pesto, top
with a selection of char-grilled marinated
vegetables such as eggplant, capsicum, and
zucchini. Layer over baby spinach leaves
and top with sliced mozzarella or bocconcini
cheese.
• Make a simple potato rosti by coarsely
grating a potato and squeezing out excess
moisture. Combine with crispy bacon pieces
and chopped chives. Pan fry in a little oil until
crisp and golden. Place warm rosti on bread,
top with thinly sliced roast beef, and spread
with seeded mustard.
• Combine chopped barbecued chicken,
nely diced onion and shredded tasty cheese
in a small bowl. Spread bread with sweet chilli
or barbecue sauce, top with chicken mixture.
• Top bread with thinly sliced salami, button
mushrooms, chopped sun-dried tomatoes
and sliced olives. Sprinkle mixed herbs over
lling and nish with sliced mozzarella cheese.
• Top bread with shaved turkey with cranberry
sauce and camembert or brie cheese. Add
sliced avocado, if desired.
• Place a fried egg on the base of a mufn,
top with sliced Colby cheese and nish with
crunchy cooked bacon strips.
• Spread bread thinly with pizza sauce, top with
shaved ham, thinly sliced pineapple rings,
sliced green capsicum and grated mozzarella
cheese and sprinkle with oregano.
• Combine softened cream cheese with
chopped capers and freshly ground black
pepper. Spread over base of bagel and top
with smoked salmon slices.
Care & Cleaning
Cleaning the interior
Switch off the power outlet and unplug the
Stainless Steel Sandwich Press; ensuring you let
the Stainless Steel Sandwich Press cool before
cleaning.
To remove burnt on llings, use a plastic scraper
after the appliance has cooled. Never use a
sharp metal object such as a knife as this will
scratch the non-stick surface.
Use a soft damp cloth or sponge to remove any
crumbs from the cooking plates before drying
the cooking plates thoroughly.
Do not clean the cooking plates with any
abrasive scouring pad or steel wool as this will
damage and scratch the Non-Stick Plates.
Storage
Your Stainless Steel Sandwich Press will store in an
upright position in cupboards, shelves or on the
worktop.
Lock the plates together using the locking latch
and wrap the power cord around the legs of the
appliance for safe and secure storage.
Specications:
Supply Voltage:.......................................240V ~50Hz
Power Consumption:......................................2000W
Note: As a result of continual improvements,
the design and specications of the product
within may differ slightly to the unit illustrated
from the packaging.

7
Notes

Cat. No. MSP610
September 2020
GSM International Ltd has a policy of continual improvement throughout the product range.
As such the unit contained within may differ slightly from the unit illustrated on the pack.
MADE IN CHINA for GSM International Ltd.
GSM International Ltd.
Gerard Sourcing & Manufacturing
Mistral is a registered trademark of GSM International Ltd.