MLis MLB-Z1001 User manual

MLB-Z1001 Quick Installation Guide
HW installation
Step 1: Please connect serial port to device as follow pinout
Pin No.
Signal Name
Function
1
DCD
Input
2
RXD
Input
3
TXD
Output
4
DTR
Output
5
GND
GND
6
DSR
Input
7
RTS
Output
8
CTS
Input
9
Not used
Step 2: Please connect to 5~32 VDC power supplier, after boot up, the LED of power will
light up.
Step 3: After plugging in power adapter. The modem is usually fully operational within 4
seconds, after powering it up. Depending on the signal strength of the network in the area,
logging into a network may take longer and is outside the control of the modem.
The device is ready after LED of signal is lighted. Then user can operate it.

SW Installation
The MLB-Z1001 Configuration Tool can be used to set Network ID,MAC Address,
Destination Address and send data for test MLB-Z1001.
Data Connection Demo
Step 1: Click the button “Read”

Step 2: “MLB-Z1001 related data” is shown

Step 3: Input ““MLB-Z1001 Tool Test”” at the window, and click the button” Send”,
Step 4: Monitor of Terminal will receive “MLB-Z1001 Tool Test”