Mobile Future X10 User manual

1
User manual
X10

2
Safety precautions
NOTICE - BREACH OF SAFETY INSTRUCTIONS COULD BE
SERIOUS BODY DAMAGE AND IN EXTREME CASES
DEATH.
• Charge your Mobile Future X10 using the included charger and
cable. Using a different one could cause product failures and void
your warranty.
• Whenever you use the product, be sure to wear appropriate clothing
with its corresponding protectors to ensure you avoid personal injury.
Wear protective clothing, such as knee pads and elbow pads or
gloves.
• Be sure to wear comfortable clothes. Above all it is important
that your shoes are closed and flat. Do not wear very baggy and
long clothes that can get into the wheels or get caught in the
product.
• Before mounting on the product, carefully read this user manual,
which explains all the basic principles and tips for using the Mobile
Future X10
• Do not use the product if it weighs less than 20 kg or if it
exceeds 120 kg.
• Before getting on the X10 , make sure the place is safe, in a flat
and smooth place. Also check that the product does not emit any
beeps or is in alert mode. Do not mount if alerts are notresolved.

3
• Do not attempt to open or modify your X10 as doing so will void
the manufacturer's warranty and could lead to serious bodily injury
or death.
• Do not use the X10in situations where you could be in danger or to the
people around you.
• Do not drive your X10 under the influence of drugs or alcohol.
• Do not drive your X10 when you have not rested well or are sleepy
• Do not drive your X10 on curbs, ramps or try stunts or tricks, as do
skaters or bikers.
• Do not turn your X10 sharply, especially at highspeeds.
• Do not use the product aggressively, you could cause product
failures and accidents.
• Never use the product to get off elevators or stairs.
• Do not drive near areas with water or muddy places (with sand, tape)
or stony. Try not to drive through very rough places.
• Do not drive in bad weather: snow, rain, hail or on icy roads, smooth
or with extreme heat.
• Do not use the X10 on slippery surfaces or steep slopes.
• If you are not sure that the surface where you use the product is
safe enough, take the device and look for other terrain.

4
• Always observe the direction you are going with the Mobile Future
X10and be careful with the people, elements of the environment,
properties and objects that surround you. Do not use it in areas where
there are many people.
• Always take care of people and their belongings when using the
product.
• Do not use the Mobile Future X10 when talking, writing a message
or talking on the phone. It could cause an accident.
• Do not drive your Mobile Future X10 on the road, trails or bike lanes.
• Do not drive the product near vehicles or on roads.
• Do not climb or lower steep slopes with the Mobile Future X10
• The Mobile Future X10is designed to be used by one person at a
time. Do not try to ride with two or more people at the sametime.
• Do not carry anything on you while driving the Mobile Future X10
• People with a lack of balance should not use this product.
• Do not use Mobile Future X10if you are pregnant or think you may be.
• Be very careful when allowing children or the elderly to use the
product. These people may not have the physical capabilities necessary
to drive safely.
• Always take into account the necessary space you must have to stop
on time.

5
• Do not jump with the product on.
• Do not drive your X10 in dark areas or in low light.
• Always make sure you have enough free space when standing on the
X10 to do it safely through doors and other obstacles at low altitude.
• Do not step on any other part of the device other than the lower base
where the feet are placed.
• Always avoid operating the product in unsafe places and where
hazardous and volatile materials are present, such as near areas with
flammable gases or liquids.
DEBE CUMPLIR CON TODAS LAS LEYES LOCALES Y/O ESTA-
TALES DE SU REGIÓN/PAÍS SOBRE EL USO DE ESTE TIPO DE
DISPOSITIVO
Before starting
After reading this manual, you should watch the videos on our website
to familiarize yourself with the product.
You can see the tutorials here
Weight restrictions
The X10 is optimized for drivers up to 120 kg and with a minimum weight
of 20 kg

6

7

8

9
Characteristics:
- Powerful 800W 48V Brushless direct drive motor
- You can select up to 3 different speeds
- 10 "front and rear pneumatic wheels
- Selectable turn signals from the control knob (4 led turn signals, 2 front and
2 rear)
- Front and rear suspension
- Max Speed 37km / h, first gear 15kmh, second gear 25kmh
- Autonomy of up to 45 km
- 13000 mAh 48V lithium battery
- Maximum charging time of 7 h
- Heavy duty aluminum folding structure with wide base, adjustable handle-
bar height, bell, horn, turn signals and kickstand.
- Indicative display of Km / hour, distance traveled, battery life and many
more functions.
- Front LED spotlight and rear brake light for maximum visibility. On the sides
it has LED lights that you can turn on / off
- Smart Energy Saving (Auto Power Off)
- Maximum weight allowed up to 120 kg
- Unfolded: 119x130x60mm / Folded: 119x450x23mm
- Unit weight: 22 Kg
- Includes: Charger and instruction manual

10
Range of Autonomy
In optimal conditions, the Mobile Future X10can travel distances of up to
45 km. However, there may be several factors for this range to decrease:
- The speed and driving style - Maintaining a moderate and continuous
speed will allow you to travel a greater distance with your Mobile
Future X10, if you drive making frequent stops, starting at idle speed
and with extreme acceleration the travel capacity will decrease. - This
product is designed for smooth and flat surfaces. Using it on uneven
terrain is not only dangerous, it will negatively affect the range of
autonomy of your Mobile Future X10 The weight of the user can
affect the range of autonomy
Inspection, maintenance and storage of your scooter
We recommend that you maintain a routine of care for your Mobile
Future X10 similar to that of a bicycle, a skateboard or a car. If you discover
any anomaly, please contact us through our website www.mobile-future.be
Care and maintenance
Check the wheels periodically to see if they are damaged or bear excessive
load. Avoid using aggressive chemicals or solvents when cleaning the
Mobile Future X10 Do not let liquids come into contact with the ports or
buttons of the Mobile Future X10 The unit can only withstand small
splashes of water. It is not waterproof, nor should it be used in waterlogged
conditions. If water or other liquids enter it, permanent damage to the
circuitry and its electronic components could result. Manipulating the unit
would imply an automatic loss of the warranty.

11
Mobile Future X10assembly:
2
Press on the folding lever and bring the handlebar
forward
Move the handlebar bar back and forth to check
that it does not move and is fixed. Check the
brake drive.
Raisethelevertofixthefoldinghandlewhilefirmly
holding the folding bar.
Turn the handlebar fixing lever and raise the bar to
the desired position. Once raised, tighten the
handle.

12
Charge connection:
Remove the rubber cap, insert the charging cable. After
loading, put the rubber cover back in place.
Charging your Scooter
Make sure your X10 charger is in optimal condition. Check that there is
no dust or dirt on the connector and if so, clean it and make sure it is dry.
Always use the original charger provided with the product and connect it
correctly to the device (through the charging port) and to a power outlet.
It is important that you always use the charger that comes with your z
X10 , otherwise, it may cause the device to fail and not be covered by
the warranty. Once the product has been loaded, it will take approxi-
mately two or three hours to complete the charge.
Cuando la luz LED cambia a color verde, significa que el producto está
completamente cargado.

English
13
It is important that at that time, immediately disconnect the adapter from
the network to stop charging. The battery life will be affected by the
battery charge time, never exceed and will extend the life of your battery.
Please note that the approximate charging time is between 4-5 hours.
Do not leave the product charging once the adapter light has changed to
green or overcharge the battery for more than 5 hours.
IMPORTANT:
a) The charge will be approximately 4-5 hours.
c) Do not overcharge the unit, as this will shorten the life of your battery
and its charger.
Tips to keep in mind when loading
- Load preferably in locations away from flammable products.
- Monitor and control the charging period (which does not exceed the
recommended).
- Use only the original charger.
- Do not leave the skate loading at night.
- If the skate has been exposed to high temperatures, wait and check
that it is not hot before loading it again.
- For the charging procedure it is important that the skate is turned off
and that there is no accessory connected, since if it is not possible for
any of the sensors to be activated and the battery will overheat.
- When the charger LED turns from red to green it is when the smart
Gyro is charged.
- Cannot be charged with ignition or working.

English
14
Preparation
Please read this user manual carefully, in its entirety, before mounting on your
new X10 .
Follow the charging instructions explained below, before attempting to use the
product.
Tips to consider
Maintain a relaxed posture:
If you are tense, and do not have a relaxed posture, the Mobile Future X10will
know and exaggerate your movements. Relax and learn to control the
direction and balance with balance.
Foot position:
When you get on the X10 make sure that you maintain an upright
position and that your feet are symmetrically aligned on the bottom base of
your X10 so that you can drive the productoptimally.
Do not move abruptly:
try to avoid moving your arms or making windbreaks, because it will modify the
posture and balance.
Descend confidently:
When your X10 is fully braked, descend with one foot to always keep your
balance. Avoid sudden movements or jump down to avoid a possible fall.

English
15
Start the march on your X10
1. Turn on the product on the display button and check the battery.
2. Initially put one foot on the skate
and when balanced start the march
striding
3. When the sliding of the skate
starts, put the second foot to
balance and press the accelerator
4. Release the accelerator finger to
decelerate and press the brake if
you wish to brake.
4. Release the accelerator finger to
decelerate and press the brake if you
wish to brake...

English
16
Disassembly and transport of your X10 :
1. Turn on the product on the display button and check the battery.
Then make sure the electric scooter is turned off and from the vertical tube
take out the folding wrench, fold the tube towards the rear wheel.
After you have folded the product, hold the vertical tube with one hand or
both hands to transport it

English
17
Maintenance:
Lubrication
Lubricate the skate folding mechanism every 6 months with a
non-corrosive neutral oil, before lubricating it, clean the surface to
remove impurities.
Braking
When the brake performance begins to decrease, you can adjust
the braking cable to achieve the required sensitivity. If after
adjusting the brake you continue to notice that it does not brake
as it should, consult our technical team about the possible
replacement of the brake pads.
Battery
This product is equipped with a very durable lithium battery. With
the passage of time and the amount of repeated charges, they
can have an impact on their autonomy.
If this occurs, contact our technical service for a possible
replacement.
General Troubleshooting
If you find problems in the operation of the product, make these
checks:
• The battery charges and the on the charger shows a power
LED (red if it is charging and green when the charge is complete.
• The display shows an error symbol.
• No cable has been released in the braking system
• Cable connectors are free of dust and moisture.
If you continue to have problems, contact our technical team for
advice.

English
18
Storage
Store your X10 indoors, which are dry places and in proper
conditions. If the ambient temperature of the storage location is below
0 ° C or above 55 ° C, choose another location. To prevent the entry
of dust and particles, store your X10 in its original packaging.
If you are going to store your X10 for a long period of time, check
that the product battery is at minimum levels. We recommend
recharging the battery every 3 months to ensure you are ready to drive
after it has been stored.
Technical Security Requirement
The power adapter is the device disconnect device. The power
outlet base must be close to the equipment and be easily
accessible.
Recycle your device
Electrical or electronic products, batteries, accumulators and
other accessories must necessarily be subject to selective
collection. When the life of your electrical or electronic device
has ended, remove the batteries and deposit them separately
in the correct container for proper management. Note that the
batteries cannot
deposit them indiscriminately together with household waste.

Portugués
19
Consider recycling following the manufacturer's guidelines.
With this gesture, it will help reduce the risks to your health and
preserve the environment. If you have any questions, ask your
city council or distributor to request the essential information
about the recycling of your old device. Nº REI-RPA
1201-RD.106 / 2008.
Important
- You should always wear a helmet and safety protectors to avoid
personal injury in case of possible falls.