Mocka Rookie Installation guide

Hardware Supplied
x2
D
long screw
x1
steering axle
A
m
Mocka Balance Bikes are designed for children aged 2-6 years. These bikes
should not be used on public roads or near traffic. Wearing a helmet is
advisable. Only one child at a time should use the bike. Recommended for
children under 35 kg.
Adult supervision is strongly recommended at all times. Ensure your child is
confident at braking and is aware of road rules & safety. All screws, steering
and axles must be checked by an adult before use.
Please keep your bike protected from water and moisture. Due to the wooden
nature of the bike, they should not be left outside for long periods of time and
should be dried down after use. We recommend storing your bike inside when
not in use. Clean with a damp cloth - do not use chemical spray cleaners.
B
x2
Allen key
C
wheel assemblies
(in place) x2
All nuts and bolts must be checked and tightened before first
use. Regularly check all screws are tight to ensure safety.
Rookie Bike
1
mocka.co.nz | mocka.com.au
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.

12
Firstly separate wheel assemblies (C) and insert plastic spacers into
both wheels as shown. Slide bike wheels into position and attach to
both the frame and fork using the bolts and nuts. Tighten with Allen key
(D).
The Rookie Bike has been pre-assembled with the seat in the lowest
position for a beginner rider. Position the frame and fork of the bike
together.
Frame
Fork
C
C
spacers
spacers
Frame
Fork
Rookie Bike
2
mocka.co.nz | mocka.com.au
Assembly Instructions

12
Firstly separate wheel assemblies (C) and insert plastic spacers into
both wheels as shown. Slide bike wheels into position and attach to
both the frame and fork using the bolts and nuts. Tighten with Allen key
(D).
The Rookie Bike has been pre-assembled with the seat in the lowest
position for a beginner rider. Position the frame and fork of the bike
together.
Frame
Fork
C
C
spacers
spacers
Frame
Fork
34
Connect the frame and fork using the steering axle rod (A). Slide the
rod down into the central hole in the top an through the end of the
frame.
Using the two long screws (B), attach the handle bars to the top of the
steering section. Tighten both screws securely with the Allen key (D).
x1
A
x2
BB
B
B
Rookie Bike
3
mocka.co.nz | mocka.com.au
Assembly Instructions

56
Use allen key (D) to release and re-tighten the pre-assembled screws
and bolts to adjust the seat.
All done! We are confident your child will have years of fun and
adventure while developing fantastic balance and co-ordination skills!
D
m
Rookie Bike
Assembly Instructions
4
mocka.co.nz | mocka.com.au