Modena Casto Series Owner's manual

User Manual Book
Air Purifier
Casto Series
AP 1523

English 2
TABLE OF CONTENT
Part 1: Important Safety Information 3
General Cautions 3
Prohibitions 3
Warnings 4
Notices 4
Part 2: Product Introduction 5
Product Components 5
Control Panel and Display 5
Part 3: How to Use 6
Panel and Display Instruction 6
Air Quality Indicator 6
Part 4: Maintenance 7
Part 5: Troubleshooting 8
Part 6: Specification 9
Appendix: Wiring Diagram 10
This manual book explains everything you need to know about your new
product. Please contact our Customer Care should you need further
assistance through www.modena.com.

English 3
General Cautions
1. Please check whether the device is fine and the components are
complete after unboxing the package.
2. Please be sure to remove the plastic package of the filter before
first time using the device.
3. Children and incapacitated person should use the device
accompanied by their superintendent.
4. Please unplug the device immediately if accident occurs, and do not
use the machine under defect condition.
5. In order to avoid danger, if the supply cord is damaged, it can only
be change by manufacturer or the qualified maintenance person.
6. Please do not use other components that are not permitted by
manufacturer, otherwise warranty will be terminated if the device is
breakdown in that case.
Prohibitions
1. Do not put your hand and foreign matter into the air inlet and air
outlet.
2. Do not unplug the power with wet hands.
3. Do not use the device at the place where full of hydogen, natural
gas, dimethylmethane, and other flammable gas.
4. Do not use the device if power cord or plug is damaged, or power
socket slacked off.
5. Do not jam the air inlet and air outlet
6. Do not use the device when using the aerosol bomb or there are oil
residue, incense smoke, alight flame, and chemical odor in the room.
And also do not use the device in deep wet place such as shower
room.
7. Do not operate the device without filter inside.
8. Do not wash or re-use the composite filter.
PART 1: IMPORTANT SAFETY INFORMATION

English 4
Warnings
1. Only 220V voltage socket can be used.
2. Hold still the plug when unplug it, and do not pull the power cord,
otherwise it will cause electric shock or sparks.
3. Unplug the device when not in use or need cleaning.
4. Clean the dust on the plug regularly.
5. Do not use strong causticity detergent when cleaning the device
because it can damage its surface.
6. Use only soft cloth to clean the surface of the device, oherwise it
will be damaged, scratched, or even fractured.
7. Do not put the device close to the heat source or even put onto it.
8. Ethyl alcohol or organic solvent are forbidden to be used to wipe the
device, otherwise it will damage the device or cause electric shock
and fire sparks.
Notices
1. Hold still the main body to move the device. Do not hold the air
outlet to move it, because it can make device fall off, which can
cause injury.
2. This device is not intended to be used by persons with special
needs for their physical, sensory or mental capabilities, or lack of
experience and knowledge (including children), unless they have
been given the supervision or instructions concerning the use of
the appliance by a person who responsible for their safety. Children
should be supervised to ensure that they are not playing with this
water heater.
3. If the device causing signal interference on the radio or television,
please follow one or more below instructions:
•Re-adjust or rotate the receiving antenna.
•Take the device far away from radio or television receiving
antenna.
•Connect the air purifier power and signal power on different
socket.
•Please contact MODENA Service Center or qualified technician
if assistance is needed.

English 5
Product Components
Control Panel and Display
PART 2: PRODUCT INTRODUCTION
Air Outlet
Control Panel
Sensor Inlet
Power Socket
Air Inlet
Display
Air Quality
Indicator Lamp
Power Button
Sleep Mode
Button
Wind Speed
Button
Timer
Button
Filter Reset
Button

English 6
Panel and Display Instructions
After plugging the power plug, the device enters
standby mode and the air quality indicator will show
red color. Press the power button to turn the device on
and it will enter the default automatic operation mode.
After the sensor is preheated, the air quality indication
is displayed. Press again the power button to turn the
device off.
Touch the sleep button to enter sleep mode. The fan
will work at low speed and the indicator light will black
out. Touch the sleep button again to exit sleep mode.
Touch timing button to set a cycle of 1-8 hours timer.
Long press it for two seconds for cancel timing.
Touch the wind speed button to change the workong
gear of the device in a cycle of A-1-2-3. The current
gear is showed when the button is pressed for the first
time, and it is adjusted when the button is pressed
again.
Filter reset button will flash after 1500 hour of use.
After changing the filter, press and hold this button
until it stop flashing to reset the filter lifetime
calculation.
Air Quality Indicator
Air Quality Status
Excellent
Good
Poor
Indicator Light Color
Green
Yellow
Red
Air Quality Value
1 –50 μg/m3
51 –100 μg/m3
> 100 μg/m3
Wind Speed
Gear 1 / Low
Gear 2 / Mid
Gear 3 / High
PART 3: HOW TO USE

English 7
Warning: The device must be unplugged before maintenance and
cleaning
Device Cleaning
1. Wipe stains with soft cloth.
2. For stubborn stains, dip some neutral liquid into the soft cloth then
clean.
Note: No hard object to scratch the device surface during maintenance
and cleaning. When tear down the device, please refer to the
instruction manual and do as the requirement to avoid damaging the
components.
Filter Cleaning and Replacement
1. Built-in program will remind to replace the filter. Due to different air
quality around, filter lifetime will also be different. Filter replacement
also can be judged from the device noise and smell.
2. If there is dust cover on the composite filter, a vacuum cleaner can
be used to clean the dust on its surface to extend filter lifetime.
Notes:
•Filter lifetime can shorten if being used for certain condition, such as
in a room where many people smoke. Please replace the filter when
purify effect is not good anymore.
•Please dispose the used filter as non-combustible garbage.
Filter Replacement Method
1. Power off the device and unplug the power plug.
2. Rotate and disassemble the air inlet net (the base of the device is
facing the operator). One hand fixes the main body, and another
hand grabs the base and rotate it counter clockwise.
3. Take out the old filter.
4. Remove the plastic packaging from the new filter.
5. Insert the new filter into the device. NOTE: filter with straps shall
face toward the base.
6. Assemble the air inlet net according to reverse direction of step 1.
PART 4: MAINTENANCE

English 8
Problem
Possible Cause
Recommended Actions
The device cannot be
turned on
The device does not plug
well.
Check the power plug
and re-plug it properly.
The air flow is weak
1. Filter package has not
been removed.
2. Foreign materials jam the
air inlet or outlet.
3. The filter is dirty.
1. Remove the plastic
package of the filter.
2. Clean foreign material at
the air inlet or outlet.
3. Clean or replace the
filter.
Dust removal effect is
not obvious and air
quality does not get
better
1. No filter in the device.
2. Door or window of the
room open frequently.
3. The device is put in
narrow place or close to
barrier around.
4. The filter is dirty.
1. Install filter into the
device.
2. Reduce the door or
window opening
frequency.
3. Move device to wider
place without any
barrier.
4. Clean or replace the
filter.
Odor comes from the
air outlet
1. Many people smoke or do
something causing odor
in the room.
2. The filter is dirty.
1. Change the indoor air.
2. Clean or replace the
filter.
PART 5: TROUBLESHOOTING

English 9
Model
AP 1523
Product Type
Desktop Air Purifier
Color
White
Control Panel
Touch Control
Filter Composition
Activated Carbon, HEPA13
UV Function
Yes
Negative Anion Function
Yes
Fan Speed
Low / Mid / High
Display
Yes
Timer Setting
Yes, 1-8 hours
Air Quality Indicator
Yes, Green-Yellow-Red
Sleep Mode
Yes
Auto Mode
Yes
Light Sensor
No
Filter Replacement Indicator
Yes
Child Lock
No
Power
7.5 W
Clean Air Delivery Rate
100 m3/h
Coverage Area
15 m2
Dimension
200 x 200 x 313 mm
Specifications of this appliance may change without notice to improve the quality of the
product. Pictures in this manual are schematic and may not match your product exactly.
Values stated on the machine labels or in the documentation accompanying it are
obtained in laboratory in accordance with the relevant standards. Depending on
operational and environmental conditions of the appliance, values may vary.
PART 6: SPECIFICATIONS

English 10
APPENDIX: WIRING DIAGRAM
PM 2.5
Sensor
DC Terminal
24 V, 1.75 A
24 V DC Motor
Control Panel
and Display

03/21