Modern RAPTOR User manual
Operator’s Manual
YOU'RE ALWAYS AHEAD...WITH A MODERN BEHIND.
15' RAPTORRR CUTTER
P.O. BOx 790 • BeaumOnt, tx 77704
409.833.2665 • 1.800.231.8198 Fax: 409.726.8333
www.modernusa.com
Go Galvanized!
PART 1 OF 2
LAST REVISION
SUMMER 2012
SPRING 2016
Operator’s Manual
15’ RAPTOR CUTTER
215’ Raptor
introduction
Verify your RPM with your local dealer prior to operation. Should you desire to change PTO input
1000 RPM drive.
all times.
315’ Raptor
operator get years of satisfactory service from the machine.
machine.
VERY SERIOUS INJURY.
OR SERIOUS INJURY.
INJURY.
INTRODUCTION
CAUTION
WARNING
DANGER
INTRODUCTION
415’ Raptor
safety section
515’ Raptor
15’ Raptorrr - 5
to YOU.
General Safety Guidelines
manual and the tractor operator’s manual. Learn how to stop the tractor engine suddenly in
manuals prior to operation.
the controls easily.
Drugs and alcohol will affect an operator’s alertness and coordination and therefore affect the
an operator on prescription or over-the-counter medication must consult a medical professional
SAFETY SECTION
SAFETY SECTION
615’ Raptor
proper and safe operation.
hearing loss. We recommend that you always wear hearing protection if the noise in the
will cause permanent or total hearing loss.
Note: Hearing loss from loud noise [from tractors, chain saws, radios, and other such sources close to the ear] is
cumulative over a lifetime without hope of natural recovery.
General Safety – Rotating Equipment
repairs. Use gloves and eye protection when servicing hot components. Contact with a hot
SAFETY SECTION
SAFETY SECTION
715’ Raptor
15’ Raptorrr - 7
Equipment Operation Safety
parts are moving. Mount the tractor only when the tractor and all moving parts are completely
stopped.
rolling. Never dismount a tractor that is moving or while the engine is running.
Accidental operation of lifting lever or a hydraulic failure may cause sudden drop of theunit
Do not put hands or feet under lifted components.
and tractor in good operating condition.
SAFETY SECTION
SAFETY SECTION
815’ Raptor
procedure. Always read carefully and comply fully with the manufacturer’s instructions when
ground speed where you can safely operate and control the tractor and implement. Never mow
closed.
safety section
SAFETY SECTION
915’ Raptor
15’ Raptorrr - 9
motion has ceased.
supported.
Equipment Operation Safety – Clearances and Obstructions
mowing.
SAFETY SECTION
SAFETY SECTION
10 15’ Raptor
10 - 15’ Raptorrr
folding or unfolding the wings.
mowing if anyone is within 100 yards of implement.
Note: Where there are grass and weeds high enough to hide debris that could be struck by the blades, the
area should be: inspected and large debris removed, mowed at an intermediate height, inspected, closely with
any remaining debris being removed, and mowed again at desired nal height. (This will also reduce power
required to mow, reduce wear and tear on the implement drivetrain, spread cut material better, eliminate
streaking, and make the nal cut more uniform).
parts of the implement head. These items could then swing outside the housing at greater
safety section
SAFETY SECTION
1115’ Raptor
15’ Raptorrr - 11
Connecting or Disconnecting Implement Safety
hitches.
assistance if the implement driveline does not match the tractor PTO.
securely in the groove on the tractor PTO shaft. A driveline not attached correctly to the tractor
SAFETY SECTION
SAFETY SECTION
12 15’ Raptor
Transporting Safety
type of vehicle. Never tow the implement and another implement connected in tandem. Never
determine the stopping characteristics of the tractor and implement. As you increase the speed
when turning sharply to prevent the tractor and implement from turning over. Determine the
ground.
SAFETY SECTION
SAFETY SECTION
1315’ Raptor
watch out for the other guy.
implements move the center of gravity to the rear and remove weight from the front wheels.
Overturning the implement could cause the implement to overturn the tractor and vice versa
overturn.
in the latched transport position. Dropping implement in transport can cause serious damage to
allow the implement wing to come within 10 feet of any power line.
Maintenance and Service Safety
SAFETY SECTION
SAFETY SECTION
14 15’ Raptor
tractor engine. Push and pull the Remote Cylinder lever in and out several times prior to starting
any of its components or any implement function.
Parts Information
SAFETY SECTION
SAFETY SECTION
1515’ Raptor
15’ Raptorrr - 15
and safety.
Safety Signs/Decals
install replacement safety signs immediately.
Concluding Safety Instructions and Practices
and storage of the machine. Refer also to safety guidelines and operation instruction in each of
SAFETY SECTION
SAFETY SECTION
16 15’ Raptor
SAFETY DECAL PLACEMENT
ITEM PART NO. DESCRIPTION QT Y.
. . . . . . . ..........COMPLETE DECAL SHEET ..........1
1...... . . . . . . . . . . . . . . . . . . DO NOT ATTACH .................1
...... . . . . . . . . . . . . . . . . . . .............1
...... . . . . . . . . . . . . . . . . . . THROWN OBJECTS ...............1
...... . . . . . . . . . . . . . . . . . . ................1
5...... . . . . . . . . . . . . . . . . . . .............
...... . . . . . . . . . . . . . . . . . . ....1
7..... ........................1
..... .... .........1
9..... ..........REPLACE SHIELDS ................1
10 .... .......... .............1
11 .... ..........CAUTION REPLACE SHIELDS .......1
12
7
77
13
10
15
12
12
13
1
1
1
9
6
7
7
9
10
5
4
3
2
1
RE-TORQUE
GEARBOX NUTS
EVERY 40 HOURS
8
8 8
Galvanized
Units Only
11
* Safety decals item #1 - 6 are sold in
complete sets only. Additional safety decals
item #7-10 can be purchased separately.
See next page for additional cutter decals.
13
10
13
14
10
SAFETY SECTION
1715’ Raptor
15’ Raptorrr - 17
15
490-1115
490-9000 Decal Sheet contains:
Cutter Size Decals
Modern Attachments
800-231-8198
490-2003
490-FEMA
490-1031
490-1023
ADDITIONAL CUTTER DECALS
490-EAGLE
490-EAGLE
BLUE
ITEM PART NO. DESCRIPTION QT Y.
.... ............ ......
.... ............. . . . . . . . . . . . .
.... ......... .......................1
15 .... ............TYPICAL SET-UP ................1
490-1000
SAFETY SECTION
490-1014
18 15’ Raptor
operation section
1915’ Raptor
15’ Raptorrr - 19
OPERATION SECTION
OPERATION INSTRUCTIONS
of all cutters. Some pictures may show shields removed for picture clarity. NEVER OPERATE this
years of safe and satisfactory use of the cutter.
IMPORTANT:
READ AND UNDERSTAND THE ENTIRE OPERATING INSTRUCTIONS AND SAFETY SECTION
OF THIS MANUAL AND THE TRACTOR MANUAL BEFORE ATTEMPTING TO
USE THE TRACTOR
AND Cutter.
the Safety Messages. Always use good common sense to avoid hazards.
medidas de seguridad.
PELIGRO
OPERATION SECTION
20 15’ Raptor
15 ft raptorrr
standard eQuipment and specifications
Front chains and rear rubber guards are standard equipment. Single and rear chain guards are available as extra
equipment at extra cost. Modern recommends cutters be equipped with deectors or chain guards for all mowing
purposes.
operation section
Cutting Width ........................
Transport Width ......................
Overall Width ........................
Overall Length .......................
Cutting Height .......................
Blade Overlap ........................
Wing Lift Hydraulics...................Standard
............................
............................Standard
Hitch ................................Swivel Clevis
Blade Carrier .........................Pan Stump Jumpers
............50 hp-75hp
...........
....................
Output Shaft Diameter ................
Cut Capacity .........................
Main or Center ...............................
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1000 .......
Wings ........................................
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1000 .......
Main ................................Cat. 5 Constant Veloc.
.............
.......................
............................
...............Standard
Safety Chains ........................
......................
.............Standard
Standard Tires ........................
Dual Tailwheels .......................
Hydraulic Level Lift....................
............
OPERATION SECTION
Table of contents
