modway EEI-1212 User manual

Customer Service 908-368-1025︱
︱︱
︱www.modwayfurniture.com Page 1 of 2
EEI -1212 BARSTOOL
Hardware:
Component:
A Nut x2
C Open Wrench x1
1 Chair Back x1 2 Chair Base x1
B Flat Washer x2
Thank you for purchasing the PROCURE BARSTOOL！
！！
！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Approximate assembly time: 15 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
1
2

Customer Service 908-368-1025︱
︱︱
︱www.modwayfurniture.com Page 2 of 2
EEI -1212 BARSTOOL
Ax2 Bx2 Cx1
STEP 1:
Hardware & Tool required
STEP 2:
Assembly is completed. The barstool is ready to enjoy now!
1
2
1
2
2
1
Please put the Chair Base (2) upside down on a carton as shown.
Insert the Chair Back (1) into the rings on the bottom of the seat frame as shown.
Attach Chair Back (1) into the Chair Base (2) by using Nuts (A) and Flat Washers (B) as shown.
Use the Open Wrench (C) to tighten the Nuts (A) clockwise until secure.
Carefully turn over the barstool.
Note: Seat Height is designed for adjusting.
Turn the seat frame clockwise to lower and counterclockwise to raise.