modway EEI-4091 User manual

EEI-3890 TOP + EEI-3913 BASE DINING TABLE
Customer Service 609-256-9000︱www.modway.com Page 1of 3
Thank you for purchasing the MODWAY DINING TABLE!
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the dining table, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of children.
Hardware:
Components:
Bolt M8x25mm x14
A.
Allen Wrench x1
1. Top x1 2. Base x2 3. Base Plate x1
( EEI-3890 TOP) ( EEI-3913 BASE ) ( EEI-3913 BASE)
C.
Flat Washer x8
D.
B.
E. Foot Pin x6
Spring Washer x8

EEI-3890 TOP + EEI-3913 BASE DINING TABLE
Customer Service 609-256-9000︱www.modway.com
Page 2of 3
STEP 1:
1. Please put the Top (1) upside down on a carpeted or padded surface.
2. Please note the holes on the bottom of Top (1) are designed to match three table bases, please find the
suitable holes to attach EEI-3890-TOP and EEI-3913-BASE you buy as shown.
STEP 2:
1. Attach 2 pieces of Bases (2)to the Top (1) by using 8 pieces of Bolts (A) with 8 pieces of
Flat Washers (B) and 8 pieces of Spring Washers (C) as shown.
3. Use Allen Wench (D) tighten Bolts (A) as shown. Don’t fully tight Bolts (A).

EEI-3890 TOP + EEI-3913 BASE DINING TABLE
Customer Service 609-256-9000︱www.modway.com Page 3of 3
STEP 3:
1. Attach the Base Plate(3)to the Base (2) by using 6 pieces of Bolts (A) as shown and use
Allen Wench (D) tighten Bolts (A). Don’t fully tight Bolts (A).
2. When all components are fixed, please fully tighten all Bolts (A).
3. Glue 6 pieces of Foot Pins (E) to the Base Plate (3) as shown..
STEP 4:
Carefully turn over the assembled dining table by two adults
Your dining table is ready to be used now!