modway EEI-2248 User manual

EEI-2248 TABLE
Customer Service 609-256-9000︱www.modway.com
Page 1 of 2
Thank you for purchasing the MODWAY TABLE.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all pieces out of reach of children.
Hardware:
Components:
Bolt M6x20mm x4
A.
B.
Allen Wrench x1
1. Leg x2 2. Table Top x1
1
2
1

EEI-2248 TABLE
Customer Service 609-256-9000︱www.modway.com
Page 2 of 2
clockwise until secure.
STEP 2:
Carefully position the table to your desired location.
Assembly is completed. The table is ready to enjoy now!
11
2
AB
1
2
3. Do not fully tighten Bolts (A) at this step.
4. Repeat the same steps for the remaining piece of Leg (1).
5. After checking the leveling for all connections, please use Allen Wrench (B) to tighten all Bolts (A)
STEP 1:
1. Please put 1 piece of Leg (1) and Table Top (2) upside down on a carpeted or padded area as shown.
2. Insert 2 pieces of Bolts (A) from the pre-drilled holes on the side rail of the Table Top (2) into each end of
Leg (1) as shown.