modway EEI-1039 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
EEI –1039 DINING CHAIR
Hardware:
Component:
A Bolt M8x50mm x 4
D Flat Washer M8 x 8
1
Chair Body x1 4 Back Leg x2
Thank you for purchasing the MODWAY DINING CHAIR!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the dining chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
2 Left Front Leg x1 3 Right Front Leg x1
B Bolt M8x65mm x 4
C Spring Washer M8 x 8
E Allen Wrench x 1
2
3
4
1
4

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI –1039 DINING CHAIR
STEP 1:
STEP 2:
Please put the Chair Body (1) upside down on a carpeted or padded area.
Then open the zipper on the bottom of Chair Body (1), to make the inside of the Chair Body (1) fully visible.
Insert the Left Front Leg (2) into the right bottom hole on the Chair Body (1) as shown.
Attach the Left Front Leg (2) by using 2 pieces of Bolt (B), 2 pieces of Spring Washer (C) and 2 pieces of Flat Washer (D).
Repeat the same steps for Right Front Leg (3).
Do not fully tighten Bolts (B) for either leg.
Insert 1 piece of Back Leg (4) into the upper hole on the bottom of Chair Body (1) as shown.
Attach them by 2 pieces of Bolt (A), 2 pieces of Spring Washer (C) and 2 piece of Flat Washer (D) as shown.
Repeat the same steps for the remaining Back Leg (4).
Do not fully tighten Bolts (A) for either leg at this step also.
2
Bx4 Dx4 Cx4 Hardware & Tool required
1
B
C
D
Ax4 Dx4 Cx4 Hardware & Tool required
1
2
3
4
C
D
A
3
1
4

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
EEI –1039 DINING CHAIR
STEP 3:
Assembly is completed. The dining chair is ready to use now!
Carefully turn over the dining chair.
Please put a heavy object or one adult seat on top of the Seat Frame (2) to pressure the chair for leveling.
Fully tighten the Bolts (A&B) with Allen Wrench (E) .
Ex1
Hardware & Tool required
E