modway EEI-2700 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
EEI –2700 DINING CHAIR
Hardware:
Component:
A Long Bolt M6x60mm x 8
1
Chair Back x1
Thank you for purchasing the MODWAY DINING CHAIR!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the dining chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
3
Chair Seat x1 3 Left Frame x1
B Allen Wrench M4 x 1
2
4
1
Right Frame x1 5 Seat Cushion x1
4
5
2

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI –2700 DINING CHAIR
STEP 1:
STEP 2:
Please put Left Frame (3) on a carpeted or padded area.
Position Chair Back (1) and Chair Seat (2) to Left Frame (3).
Insert the tenon on Chair Seat (2) into the rabbet on Left Frame (3) at first.
Then insert the tenon on Chair Back (1) into the rabbet on Left Frame (3) as shown.
Position Right Frame (4) to the assembled Chair Back (1), Chair Seat (2) and Left Frame (3) as shown.
Insert the tenon on Chair Seat (2) into the rabbet on Right Frame (4).
Insert the tenon on Chair Back (1) into the rabbet on Right Frame (4).
2
1
3
1 2
3
4

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
EEI –2700 DINING CHAIR
STEP 3:
Assembly is complete. Your chair is ready to be used now!
Carefully turn over the assembled Chair Back (1), Chair Seat (2), Left Frame (3) and Right Frame (4).
Insert 2 pieces of Bolt (A) into the pre-drilled hoes on Chair Back (1) through the top pre-drilled holes on Left Frame (3).
Insert 2 pieces of Bolt (A) into the pre-drilled hoes on Chair Seat (2) through the top pre-drilled holes on Left Frame (3) .
Use Allen Wrench (B) to tighten Bolts (A) clockwise until secure.
Repeat the same steps for Right Frame (4).
Hardware & Tool required
Ax8 Bx1
Carefully position the assembled chair to the desired location.
Put Seat Cushion (5) into the assembled chair .
Tie Seat Cushion (5) to Chair Back (1) by using the banding on the back of Seat Cushion (5) as shown.
STEP 4:
A
A
A
A
1
3
A
B
5
A
4
2
A
Banding on the back of seat cushion