modway EEI-2263 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2
EEI-2263 ARMLESS CHAIR
Hardware:
Component:
A Bolt M6x20mm x4
B
C Allen Wrench M4 x1
1 Top Rail x1
Thank you for purchasing the MODWAY ARMLESS CHAIR！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
2
1
Bolt M6x25mm x6
2
3 Seat Frame x1
3
2 Leg x2
4
5
4 Seat Cushion x1 5 Back Cushion x1

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
EEI-2263 ARMLESS CHAIR
STEP 1:
Ax4 Bx6 Cx1 Hardware & Tool required
STEP 2:
Assembly is completed. The chair is ready to enjoy now!
Carefully place the assembled chair at your desired position.
Put the Seat Cushion (4) and Back Cushion (5) to assembled chair frame as shown.
C
B
2
The bottom of seat frame and legs
The bottom of top rail and legs
2
1 B
C
The bottom of seat frame and legs
Remove the plastic covers which pre-install in the end of the Seat Frame (3) by using Allen Wrench (C).
Please put 1 piece of Leg (2) on a carpeted or padded area.
Insert Top Rail (1) and Seat Frame (4) into the Leg (2) as shown.
Insert 3 pieces of Bolt (B) from the pre-drilled holes on the bottom of the Top Rail (1) and Seat Frame (4) into each side
on the bottom of Leg (2).
Insert 2 pieces of Bolt (A) from the pre-drilled holes on the side rail of the Seat Frame (4) into each end of the Leg (2) as shown.
Do not fully tighten Bolts (A&B) at this step.
Repeat the same steps for the remaining 1 piece of Leg (2).
After checking the leveling for all connections, please use Allen Wrench (C) to tighten all Bolts (A&B) clockwise until secure.
1
2
2
3
3
2
3
A
C
4
5