modway EFFUSE EEI-1205 User manual

Customer Service 908-368-1025︱
︱︱
︱www.modwayfurniture.com Page 1 of 3
EEI -1205 DINING TABLE
Hardware:
Component:
1 Table Top x1 2 Leg x2
1
Thank you for purchasing the EFFUSE TABLE！
！！
！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
3 Bottom Rail x2
2
3
2
3
A Hex Head Bolt
with Spring Washer
and Flat Washer
E Allen Wrench x1
C Flat Washer x8
B Bolt x8
D Open Wrench x1
Note:
The 4 sets of Hex Head Bolts with Spring Washers and Flat
Washers (A) are pre-installed at the end of Bottom Rail (3).
x4

Customer Service 908-368-1025︱
︱︱
︱www.modwayfurniture.com Page 2 of 3
EEI -1205 DINING TABLE
Ax4 Dx1
STEP 2:
Hardware & Tool required
Please put the legs (2) upside down as shown.
Insert 2 sets of Hex Head Bolt with Spring Washer and Flat Washer (A) into the pre-drilled holes on the Bottom Rails (3)
through the pre-drilled holes on the Leg (2) as shown.
Use Open Wrench (D) to tighten the 2 sets of Hex Head Bolt with Spring Washer and Flat Washer (A) clockwise until secure.
Repeat the same steps for affixing the other Leg (2).
Dx1 Tool required
Loosen the 2 sets of Hex Head Bolts with Spring Washers and Flat Washers (A) which come pre-installed at the end of
Bottom Rail (3) by using Open Wrench (D) as shown.
Repeat the same steps for loosening the other Bottom Rail (3).
STEP 1:
2
2
3
3
3

Customer Service 908-368-1025︱
︱︱
︱www.modwayfurniture.com Page 3 of 3
EEI -1205 DINING TABLE
STEP 4:
Assembly is completed. The dining table is ready to enjoy now!
Carefully turn over the dining table.
STEP 3:
Bx8 Cx8 Ex1 Hardware & Tool required
Please put the Table Top (1) upside down on a carpeted or padded surface.
Attach the assembled Legs (2) into the bottom of the Table Top (1) by using Bolts (B) and Flat Washers (C) as shown.
Use Allen Wrench (E) to tighten the Bolts (B) clockwise until secure.
2
2
3
3
1
2
1