modway EEI-3578 User manual

EEI-3578 BENCH
Customer Service 609-256-9000︱www.modway.com
Page 1 of 3
Thank you for purchasing the MODWAY BENCH.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the Bench, we recommend that it is assembled by two adults, on a carpeted
or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all pieces out of reach of children.
Hardware:
Components:
Bolt M8x60mm x8
Flat Washer x8
1. Bench Body x1 2. Leg #2 x2 3. Leg #3 x2
B.
Allen Wrench M8 x1
A.
C.

EEI-3578 BENCH
Customer Service 609-256-9000︱www.modway.com
Page 2 of 3
STEP 1:
1. Take out 2 pieces of Legs #2 (2), 2 pieces of Legs #3 (3) and hardware package in the carton..
2. Please put Bench Body (1) upside down on a carpeted or padded surface by two adults.
Open the HOOK & LOOP on the either side at the bottom of the Bench Body (1).
+ Hardware
STEP 2:
1. Please note there are labels on the corners of the Bench Body (1) and each leg, please make sure the each
leg match to the right location.
2.Attach 1 piece of Leg #2 (2) to the corner of the Bench Body (1) by using 2 pieces of Bolts (A) with 2 pieces
of Flat Washers (B) as shown.
3. Use Allen Wrench (C) to tighten Bolts (A). Don’t fully tight Bolts (A).
4. Repeat the same steps for the other 3 pieces of Legs as shown.
5. When all Legs are fixed, please fully tighten all Bolts (A).

EEI-3578 BENCH
Customer Service 609-256-9000︱www.modway.com
Page 3 of 3
STEP 3:
1. Close the HOOK&LOOP on the bottom of the Bench Body (1).
2. Carefully turn over the assembled Bench by two adults as shown to avoid leg crack.
Assembly is complete. Your Bench is ready to enjoy now!